Specification
Notes before installation :
1.Please check that all components are present.
2.Before installation ensure that all feed lines are clear of debris and on/o valve is present.
3.Ensure water pressure is between 20-125 PSI (includes combination of hot and cold feed
lines).
4.Pictures in the manual are general in content and may not represent exactly your purchased
faucet. If you are having diculties please contact a professional plumber.
5.If you will be away from home for an extended period you should shut o the main water
supply.
Daily maintenance
1.Dip the cloth into mixture of white vinegar and water (50/50) and scrub to remove
hard-water spots.
2.Check aerator (if present) regularly for calcium build up are when water stream is not
optimum.
3.DO NOT use caustic cleaning products as the use will break down nish and will void the
product warranty.
4.Acceptable cleaners include mixture of white vinegar and water (50/50) or mild
non-abrasive liquid detergents.
5.If the water pressure appears to be less than optimum remove, inspect, clean or replace
aerator.
Thank you for purchasing our faucet. The faucet you have purchased is
crafted out of the highest quality nickel, brass and stainless steel. Each and
every faucet was tested and carefully inspected by hand before delivering to
our retailers.
Please read the instructions carefully to prevent any malfunction and
damages to your plumbing and property.
1. Turn o all water supply lines and drainage lines.
2. Clean the installation area thoroughly and remove any excess debris.
The tools below are required to complete the installation. Some may not be
needed depending on the model of the faucet that you are installing. For
additional information, check with your local hardware store on the
requirements for your installation.
Adjustable Wrench
Safety Glasses
Pliers
Philips Screwdriver Flashlight
Thread Seal Tape
DESCRIPTION
• Flexible supply lines with 3/8“ or 9/16" compression ttings
FLOW
Kitchen Faucet:
• North America: 1.5 gpm max (5.7L/min) at 60psi
• California: 1.2 gpm max (4.5L/min) at 60psi
Single-Handle Lavatory Faucet:
• North America: 1.8 gpm max (6.8L/min) at 60psi
• California: 1.8 gpm max (6.8L/min) at 60psi
1.Assemble all the
hardware, nuts, and
attachments in the
correct order.
3.If the product hose thread
does not match, an additional
adapter is required.
Adapter
2.
Assembly rubber washer,
metal washer and lock nut
onto faucet,then use the
screwdriver to tighten the
lock nut.
Rubber Washer
Metal Washer
Locking Clamp
Rubber Washer
Metal Washer
Locking Nut
Screw
Helpful Hint:
Always use the supplied
rubber washers on water
supply connectors to prevent
leaking. Also, always use an
adequate amount of
plumber’s putty or thread
sealing tape to prevent
connectors from leaking.