Metal Garden Shed OWNER'S MANUAL Instructions for Assembly T-PSF56-H154 Requires two people and takes 1-2 hours for lnstallation.
BEFORE YOU START Owner's Manual Prior to installation, it is important that you contact your local government authority to determine if building approval is required. Study and understand this owner's manual. Important information and helpful tips will make your construction easier and more enjoyable. Assembly instructions Instructions are supplied in this manual and contain all appropriate information for your building model. Review all instructions before you begin.
PLAN AHEAD Site Selection l Avoid overhanging trees as much as possible as leaves will make regular cleaning necessary and broken branches are a potential hazard. l Small trees,bushes or fences nearby can be helpful,acting as a wind break. Site Preparation The site must be prepared so that the base of the shed is level all round and checking with a spirit level is required. The base can be constructed by treated timber or concrete,in order to stop the moisture getting into the shed.
NO. PART 1 Qty. NO. 2 15 1394mm 3L 1 17 4 981mm 1 20 608mm 4L 2 1509mm 608mm 3R Qty.
NO. PART P1 Qty. NO. PART Qty. 6 1560mm P2 4 1560mm P3 2 1 D1 1560mm P6 2 1550X415mm 1560mm P4 2 1509mm P5 2 1509mm P7 1 1 D2 1509mm P0 2 888mm NO. PART Qty.
GC 15 P4 17 GC P5 P7 17 17 P5 GC P4 17 21L 15 GC C3 P0 C6 P0 C1 21R C5 C4 C2 9 P2 10L P3 P1 10R P1 P1 P2 P1 P1 1 7 4L 3L 4R 5 P2 20 P1 P2 20 25L 20 P6 25R 20 GB P3 8 20 D2 11 20 P6 D1 1 3R 6
NO. PART Qty. 4L 1 4R 1 4L F1 4R NO. PART 1 Qty. 2 F1 4L 4R 1 F1 1 NO. PART Qty.
NO. PART 5 Qty. 1 F1 F1 5 1、When diagonal measurements are equal,the frame is square. 2、The Floor Frame must be BOTH square AND level or the holes will not line up properly. NO. PART Qty.
NO. PART Qty. 1 P2 Ⅰ Ⅰ P2 5 S3 S3 F1 Ⅱ Ⅱ F2 NO. PART Qty. P1 1 P1 S3 5 F1 NO. PART Qty.
NO. PART Qty. 1 P6 P6 S3 5 F1 NO. PART Qty. 1 P2 Ⅰ P2 S3 S3 F1 Ⅱ F2 NO. 5 PART Qty.
NO. PART Qty. Ⅰ 1 P2 P2 S3 4R F2 NO. PART S3 F1 Ⅱ 4L Qty. 10L 1 10R 1 10R F1 10L S3 F1 4R 4L NO. PART Qty.
NO. Qty. PART 7 1 8 1 G2 4 6 1 7 S3 F1 8 7&8 8 7 G2 6 NO. PART Qty. P1 4 P3 2 P3 P1 P1 P1 S3 P3 S3 F2 P1 NO. PART F1 Qty.
NO. PART Qty. C1 1 C2 1 C2 C1 F1 S3 21L&21R F1 C1 C1&C2 C2 NO. PART Qty.
C5 NO. PART Qty. C5 1 C6 1 C5 F1 S3 F1 C6 NO. P4 PART Qty.
NO. PART Qty. 15 2 17 4 GC 4 17 17 F1 S3 15 GC F1 17 15 17 NO. PART Qty. D1 1 D2 1 GB 2 GB F2 D1&D2 x2 NO. PART 20 6 F1 20 Qty.
NO. GD PART Qty.
Metal Garden Shed OWNER'S MANUAL Instructions for Assembly If you bought metal shed and window set at the same time, please read this manual. If not, please ignore manual The window set is only used to replace YX- Series metal shed with 156x43cm metal wall panels Requires two people and takes 0.1 hours for lnstallation.
P1-1 P1 P1-1 P3 P1-1 Disassemble P3 S3 F1 Pay attention to direction of window make sure it assembles correctly.
