Installation Condition 1.Refer to the {Standard Part List) when unpacking check all parts available . 2.Do not disassemble mixer body by yourself. 3. Connectinlet hoses to supply valves. 4 Make sure inlet pipes and supply valves have been installed and cleaned, also ensure no impurities in pipeline. 5 After installation , check all joints for leakages. snuggest don't fit the faucet in the severely corrosive environments.
Sing Basin Faucet Part List SIN Description No.s 1 Body of mixer 1 2 Base installation part 1 3 Flexible hoses 2 4 Fixing nuts 1 5 Use's manual 1 & Gloves 2 Sing Basin Faucet Installation step 1 step 2 k 3fimm-a0amm hol vA AB Please make sure there is a hole with Put the mixers body with flexible hoses ¢ 1 5/18” jon onto the sink through the hole, then the sink. Then dismantle the fixing nuts assemble the fixing nuts to the tap from from the mixer, and put on the gasket the boll om.
Sing Basin Faucet Installation step 3 step 4 Fasten the fixing nuts by spanner, and Connect the two flexible hoses to the tighten the cross screws on the fixing angle valves . Referring to the red and nuts by cross screwdriver. blue point signals on the handle, please connect them to hot water valve and cold water valve accordingly. step § 1, Operating handle gradually is better for valve protection. 2.
Care and Maintenance in order to keep the mixer surface bright, please clean the mixer regularly. Rinse faucet with clean water and wipe with soft cotton cloth. Avoid suing cleaning powder, harsh cleaning chemicals, brushes,and cloth with coarse surface to prevent scratching and corrosion. Do not use acid cleaner to clean the faucet as it may cause surface corrosion of the faucet. if the faucet comes into contact with harmful acid substances, please rinse it with water immediately.