Installation and Operating

ManualsBrandsMonessen ManualsFireplace/Gas Stove AccessoriesHand Held Remote Control Unit with Thermostat, 90 Minute Countdown Timer, Childproof Protection, 16 Security Codes, Backlit LCD Display and Soft-touch Finish

50D0104 RCSTE Rel 0 Feb 10 2006 Page 1 of 7 Ambient Technologies

A Division Of Monessen Hearth Systems

RCSTE

Thermostatic On/Off Remote Control – 120VAC

INSTALLATION AND OPERATING INSTRUCTIONS

This wireless 120VAC thermostatic on/off/ remote control – system provides a safe, reliable, and user-friendly

remote control for millivolt valve gas appliances. The system can be thermostatically or manually turned on and off

with the transmitter. Always check the appliance home owner’s manual for additional information, or warnings

regarding accessory installation before connecting this remote control system.

Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately contact the

dealer from whom you purchased the kit. Do not attempt to install any part of the kit unless all parts are in good

condition. Please keep this booklet for future reference.

CONTENTS OF KIT

Description Qty

Transmitter 1

Battery Alkaline AAA (for Transmitter) 3

Receiver (Assembly) consists of : 1

Receiver Box

Slide Button-Black (On/RS/Off)

Wall Cover Plate-Black 1

Plug-In Wiring Assembly – 22” Inches 1

Velcro (Loop and Hook) 1

Installation Instructions 1

#6 3/4" Screws ,Zinc (for Wall Cover Plate) 2

FEATURES/SPECIFICATIONS

• Easy Access Thermostatic Control

• Battery Powered Transmitter

• Low Battery Indication for Transmitter

• Child Proof Lock-out

• 16 Security Codes

• Compact 120 VAC Adapter with 30” Wire

• Optional 6 Hour Shut Down on Receiver

• Quick Disconnect Wiring Assembly

• Reset Button

WARNING

Important Safety Information

• Read this manual thoroughly prior to installing, programming or operating any remote control.

• This remote control system is designed for use with a millivolt gas valve system. Do not use this remote

control system on applications with voltages above 30 Volts AC.

Summary of content (7 pages)

PAGE 1
RCSTE Thermostatic On/Off Remote Control – 120VAC INSTALLATION AND OPERATING INSTRUCTIONS This wireless 120VAC thermostatic on/off/ remote control – system provides a safe, reliable, and user-friendly remote control for millivolt valve gas appliances. The system can be thermostatically or manually turned on and off with the transmitter. Always check the appliance home owner’s manual for additional information, or warnings regarding accessory installation before connecting this remote control system.
PAGE 2
Do not short (or jumper) across the gas valve terminals to test the remote control installation. This could damage the unit and void the warranty. • This remote control system should only be used as described in this manual. Any other use is not recommended and will void the warranty. NOTE • Due to the sensitive temperature monitoring components in the transmitter, it is necessary to allow the transmitter to stabilize to room temperature before accurate room temperatures are displayed.
PAGE 3
Installing Wire This system comes with an 22 inch pre-assembled wire assembly. Insert the white terminal to the back of the receiver. The terminal wire block can only be installed one way. Do not force the terminal plug onto the receiver. Follow the homeowner’s manual for connecting the two (2) 1/4” female spade terminals to the millivolt valve. For applications longer than 22 inches, use 18 gauge wire, 105ºC rated, with as few splices as possible. Connect to the two (2) 1/4“ female spade wiring terminals.
PAGE 4
Dip Switch (Default) Transmitter Receiver ON WARNING ON DIP DIP Do not use two (2) or more remote control systems in the same area with the same dip switch settings, as they will communicate with each other. This may cause the appliances to malfunction. Reset Button 1. The reset button can be used to reset the transmitter if transmitter is not working properly. The reset button is located behind the battery door cover.
PAGE 5
Manual Mode 1. Press the ON button once to turn on the appliance. 2. Press the OFF button to turn it off. Thermostatic Mode 1. 2. 3. 4. 5. Press the AUTO button to enter the thermostatic mode. “SET” temp icon will appear on the lower LCD screen In thermostatic mode, press the ON/▲ button or OFF/ ▼ button to set the desired set temperature.
PAGE 6
Receiver Slide Switch 1. 2. 3. ON position: the system will remain on until the slide switch is placed in the OFF or RS position. RS position: the system will only operate if the remote receiver receives a signal from the transmitter. OFF position, the system is off. The slide switch should be placed in the OFF position if you will be away for an extended period of time.
PAGE 7
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.