Operation Manual

12 ENGLISH
2-1. Before You Begin
Installation Precautions
When you install and test the MonCaso 932S series system, observe all warnings
and cautions in the installation instructions.
To avoid injury, be careful of:
 Sharp pins on connectors
 Sharp pins on printed circuit assemblies
 Rough edges and sharp corners on the chassis
 Hot components (like processors, voltage regulators, and heat sinks)
 Damage to wires that could cause a short circuits
Observe all warnings and cautions that instruct you to refer computer servicing to
qualified technical personal.
Prevent Power Supply Overload
Do not overload the power supply output. To avoid overloading the power supply,
make sure that the calculated total current loads of all the modules within the
computer is less than the output current rating of each of the power supplies
output circuits.
Observe Safety and Regulatory Requirements
Read and adhere the instructions in this section and the instructions supplied with
the chassis and associated modules. If you do not follow these instructions and
the instruction provided by the chassis and module suppliers, you increase safety
risk and the possibility of noncompliance with regional laws and regulations. If the
instructions for the chassis are inconsistent with the instructions for associated
modules, contact the supplier‟s technical support to find out how you can ensure
that your computer meets safety and regulatory requirements.