Instruction Manual

MicroShockDetector plus
- 10 -
3.2 O P E R A T I O N O F M O N I L O G
®
M i c r o S h o c k D e t e c t o r
p l u s
The CONTROL button is available for operating the device, which can have different functions
depending on the current status and the duration of the button press. The current status is indicated
by the 2 LEDs.
Checking the on-state of the device
In order to determine whether the device is switched on or off, briefly press (<3 s) the
CONTROL-button:
STATUS LED does not light up → the device is OFF
STATUS LED briefly lights up → the device is ON
Switching on the device
To turn on the device, press the CONTROL-button for at least 3 seconds until STATUS LED lights up.
After that, release the button. Once the green STATUS LED stops lighting up the device is ready for
operation. If the device is provided with an On/Of password, it can only be activated via the
software. This is indicated by the STATUS LED flashing for 60 s. If the software is not activated, the
device switches off again after 60 seconds. To activate the device, connect the device to a PC while
the LED is flashing and start the MONILOG
®
Analyzer. When reading out the device, it is
recognized that the device is password-protected. At this point you will be asked to enter the device
password. Follow the instructions in the software to switch on the device. Explanations on the
configuration of the switch on/off password can be found in the chapter 4.3.8 in the section
„Configure password“.
If no password is required, the device starts recording data immediately.
Switching off the device
To switch off the MicroShockDetector plus, keep the CONTROL-button pressed for at least 2 seconds
until the ALARM LED flashes red. If you continue to keep it pressed, the STATUS LED lights up red
for 1 s. Now it can be released. Then the device switches off. This can be verified by briefly pressing
the button. If the button is released while flashing, the device remains switched on.
If the device is provided with an On/Of password, it can only be deactivated via the software.
In order to signal this, the STATUS LED starts to flash rapidly red when the button is pressed for a
long time (> 3 s). To switch off the device, connect the device to a PC and start the MONILOG
®
Analyzer. When reading out the device, it is recognized that the device is password-protected. At
this point you will be asked to enter the device password. You can now switch off the device using