Manual

Preparing for Operation
3-7
Positioner SIPART PS2/SIPART PS2 PA
C79000-G7476-C150–01
3.3.3 Mounting kit “Rotary Actuator” 6DR4004–8D
The following are included in the supply of the mounting kit “Rotary actuator” (see Fig. 3-6 for item
Nos.):
Item No. Quantity Designation Remarks
2 1 Coupling wheel Mounting on position feedback shaft of SIPART PS2
3 1 Driver Mounting on end of actuator shaft
4 1 Multiple scale Indication of actuator position, comprising 4.1 and 4.2
4.1 8 Scale Different divisions
4.2 1 Pointer Reference point for scale (adhesive label)
14 4 Hexagon head screw DIN 933 – M6 x 12
15 4 Lock washer S6
16 1 Fillister head screw DIN 84 – M6 x 12
17 1 Washer DIN 125 – 6.4
18 1 Hexagon socket screw Premounted with coupling wheel
19 1 Allen key For item 18
3.3.4 Assembly Sequence (see Fig. 3-6)
1. Place VDI/VDE 3845 mounting console ((9), actuator-specific,
scope of supply of actuator manufacturer) onto rear of positioner
and secure using hexagon head screws (14) and lock washers (15).
2. Adhere pointer (4.2) onto mounting console in the center of the cen-
tering hole.
3. Push coupling wheel (2) onto positioner axis as far as possible, pull
back by about 1 mm, and tighten hexagon socket screw (18) using
the supplied Allen key.
4. Place the driver (3) onto the end of the actuator shaft and secure
using Fillister head screw (16) and washer (17).
5. Carefully place positioner with mounting console onto the actuator
such that the pin of the coupling wheel engages in the driver.
6. Align the positioner/mounting console assembly in the center of the
actuator and screw tight.
(Screws not included in delivery; they are part of the actuator moun-
ting console!)
7. Following startup as described in Section KEIN MERKER: Drive
actuator to end position and adhere scale (4.1) onto the coupling
wheel (2) according to the direction of rotation or the turning range.
The scale is self-adhesive!