User manual

Via Laptop/ PC/ Mac
1. Turn the S300 on from standby mode. The LED on the front
will ash blue, rstly in pattern 2 then pattern 1.
2. When it changes to Pattern 1, it is searching for a wireless
network. Press and hold the AirstreamConnect/ Airstream
Direct Button (Item 5 on Page 3) for approximately 12
seconds until the LED on the front ashes white (Pattern 3).
3. On the Laptop/ PC, go to the Wireless network selection
tool. For Windows Operating System go to step 4, for Mac
Operating System go to step 6.
4. In the list will be your network (probably with “Connected”
next to it), and any other wireless networks within range.
One of them will be AirstreamConnect****** (where the 6
*’s are the last 6 digits of the S300’s unique Mac Address).
5. Click on AirstreamConnect, and then the Connect button.
After a few seconds, you will be connected to the Airstream
Connect wireless network.
Continue to step 7.
6. On a Mac, click on the wireless network signal strength
indicator located in the bar at the top of the desktop.
Continue to Step 7 below.
9
On a Windows 7 Machine, click on the Wi-Fi strength
indicator in the bottom right hand corner. If it is
hidden, click on the little up arrow.
HINT
monitoraudio.com
Model : airstream s300
IC : 5928A-MA191819
FCC ID : O7VMA191819
The Laptop, PC or Mac must be wireless enabled with
wireless turned on.
HINT
If Airstream Connect isn’t displayed, click the refresh
arrows (top right corner of the window).
HINT
With both Windows and Mac OS’s, if AirstreamConnect
isn’t displayed, come out of the selection window and
then try again after a few seconds.
HINT