User manual
16
8. The web page will now change showing the progress of the
update. At the same time, the LED will go through various states
and colour changes indicating dierent stages of the update
process:
White (Flashing very fast) - Updating the rmware.
Cyan (Illuminated for 2 seconds)
OFF - Update complete.
The S300 will now go into standby mode.
9. The update is now complete. The web page might not say that
it is 100% complete, but when the S300 goes into standby
mode (standby button illuminated red), it has completed the
update process. Close the web browser.
10. Press the standby button and the S300 will go through the
initial start up procedure described on page 4.
Checking Firmware Version
It is possible to see what version of rmware and software the
S300 is running. This may be needed when contacting Monitor
Audio.
1. With the S300 powered up and out of standby mode, connect
your iOS-device to the USB port of the S300 using the Apple
supplied lead.
2. On the device, go to Settings, then General and then About.
3. In the About section scroll down the screen to Airstream
S300.
4. Select Airstream S300 and you will see a screen showing the
Manufacturer, Model, rmware version and hardware version.
If the update sequence diers from above, the update
may have failed. Please retry using the USB update
or web portal update. Also check the support section
of www.airstream-ma.com
HINT