User manual

Audio Generator
4-18
AM700 Audio Measurement Set User Manual
Figure 4-6: Waveform control display
The amplitude and frequency setting for the selected generator are displayed in the
edit fields for Frequency and Amplitude. Values in these fields are parameters of the
generator output signal when not sweeping. When sweeping, using the sine wave
signal, if one of the sweep parameters is fixed, the amplitude for example, then the
value set here for amplitude is the fixed amplitude for the frequency sweep.
To enable you to quickly change the type of waveform sent by the generator, the
Waveform selection soft key (described previously) is also available in this screen.