User manual

Index
AM700 Audio Measurement Set User Manual
Index-9
Serial Ports, 2-37
Set Ref, 2-29
Generator, 4-35
Set Ref key, 2-30
Settled
Level Min., 4-68
Resolution, 4-70
Samples, 4-69
Timeout, 4-69
Tolerance, 4-69, 4-70
Variation Type, 4-70
Settled Data Point Detection, 4-66
Settling Mode, Exponential or Flat, 4-67
Setup for Operation, 3-1
Shaped Noise, 4-7
Signals
Chirp, 4-7
Follow A, 4-9
Follow Analog, 4-9
IMD
CCIF, 4Ć6
SMPTE, 4Ć6
Jittered Sine, 4-9
Multitone, 4-8
Polarity, 4-7
Shaped noise, 4-7
Sine wave, 4-6
Tek Polarity, 4-7
Tone burst, 4-6
User, 4-7
Sine Wave, 4-6
Single-Ended Analog Input, 2-33
SMPTE IMD, 4-6
Snap to Data, 2-12
Sound
headphones, 2-27
On button, 2-27
volume control, 2-27
Sound source, 2-27
special signals, for valid measurements, 4-52
Specifications
Analog Analyzer, A-1
Analog Generator, A-10
Audio Analyzer Application, A-39
Audio Scope (Monitor), A-47
Digital Audio Unit, A-16
Digital Interface Tester, A-49
Dynamic Characteristics, A-29
Electromagnetic Compatibility, A-31
Electronic Triggers, A-10
Environmental Characteristics, A-29
FFT Analyzer, A-42
Floppy Disk Drive, A-25
Front-Panel Hardware, A-26
Generator Controls, A-35
Generator Signals, A-37
Mechanical Characteristics, A-33
Power Distribution System, A-27
Rear-panel Hardware, A-26
Remote-control Protocol, A-34
Safety Certification Compliance, A-28
Safety Standards, A-28
Software Update Procedure, A-24
Spectral display, FFT Analyzer, 4-85
Spectrogram Display, FFT Analyzer, 4-86
Spectrum, 4-81
Standard clock frequencies, digital interface,
4-123
Start Regulation, 4-43
State Saving, 2-18
Status Panel, Generator, 4-15
Stereo Pair, triggering, 4-104
Stop Regulation, 4-43
Storage, file transfers, 2-19
Storage button, 2-19
Storage Manager, 2-19, 4-132
subframe difference, Digital Interface Tester,
4-114