User manual

AM700 Audio Measurement Set User Manual
3-1
Configuring the AM700
This section is a general discussion of how you set up the AM700 Audio Measure-
ment Set.
AM700 Setup for Operation
Turn the AM700 on. Unless otherwise directed, it loads and runs the FFT Analyzer
application. After the FFT Analyzer application begins running, you can select any
other application you wish to use. The choices are shown in Figure 3-1.
You can start an application other than FFT by pressing and holding in the
front-panel button for the application you want to start. The AM700 will beep twice,
and you can then release the application front-panel button. To run the power-up
diagnostics, press and hold in the front-panel Limits button as you press the
front-panel power button. The AM700 beeps twice, displays the message ‘Start
mode “RUN DIAGNOSTICS” recognized,’ then runs the diagnostics before
initialization.
Figure 3-1: Applications selection buttons