Owner's Manual
Table Of Contents
- Owner's Manual
- Contents
- Important Safety Instructions
- Re-cycling
- RoHS Declaration of Conformity
- Unpacking
- Introduction
- Setting up and Positioning
- Optimum Positioning
- Fitting the Apex 10 to a Wall or Ceiling
- Apex 10 Fixing Configurations
- Adjusting the Apex 10 Bracket Assembly
- Fitting the Apex 40 to a Wall or Ceiling
- Apex 40 Fixing Configurations
- Grille Badge Fixing
- Specifications
- Guarantee and Service
- Claims under this Guarantee
- EC Declaration of Conformity
- Data Protection
- Owner Information
- Loudspeaker & Subwoofer Initial Set Up Guide
- Important Information
- Apex 10 Wall Fixing Template
- Mounting Information
- Important Safety Instructions
ADJUSTING THE APEX 10 BRACKET ASSEMBLY
The clamping mechanism can be adjusted horizontally and vertically. This is achieved by
taking the weight of the cabinet and loosening the clamp screw (Hex Key included). The
cabinet can now be adjusted at both pivot points 1 and 2 (as shown in the illustration
below). When satisfied with the positioning, tighten the screw.
DO NOT try to adjust the angle of the speaker with the clamp screw tightened.
THIS MAY CAUSE DAMAGE AND INVALIDATE YOUR WARRANTY.
Apex 13