Owner's Manual

Setting up the Bronze FX
The Bronze FX’s are paired, but specically, right hand and left hand units. Of which both can be congured
to bi-pole (normal operation) or di-pole modes. The factory setting is bi-pole.
In bi-pole mode, all speaker units (mid/ bass unit and tweeters) are in phase. This feature is designed for
when the Bronze FX is set up as a rear/surround speaker in a typical 5.1 channel system, or alternatively in
a 7.1 channel system without a second pair of FX’s for rear/ surround duties.
In di-pole mode, the front ring tweeters are out of phase with the other tweeter and mid/bass unit. It is
best to implement this conguration when using two pairs of FX’s as part of a 7.1 channel system, with the
FX’s taking up positions on the side and rear walls. Please note that they are left and right handed. This
is not an issue when used in bi-pole mode. It is essential that they are positioned correctly if used in a 7.1
channel system. Please refer to the positioning section on page 4 and the following images. In all cases
experimentation is advised to get the best set up for you.
NOTE: Before changing your Bronze FX’s from bi-pole mode to di-pole mode, please ensure
that the amplier is turned o. This protects the amplier and speakers.
monitoraudio.com 5
LEFT
Di-Pole
Bi-Pole
RIGHT
Di-Pole
Bi-Pole
Di-Pole
Bi-Pole
Di-Pole
Bi-Pole
90-110°
22-30°
5.1 system with surround speakers on the side wall
(oorstanding/ stand mounters can also be used).
ENGLISH