User guide

monitoraudio.co.uk 9
SPECIFICATION
Low frequency limit:- 27Hz
Upper frequency limit:- 40 – 150 Hz Variable
Low pass filter alignment:- 12dB/ Octave variable, plus 12dB/ octave fixed at 150Hz
Cabinet Specification: - Sealed Cabinet
Input Connections:- 2 x Stereo, 1 x LFE RCA Connections.
Amplifier Output:- 200 Watts (RMS)
Standby Power Consumption:- 0.17 Watts (ErP Certified)
Amplifier classification:- Class- D Digital amplifier, with switch mode power supply
Driver compliment:- 1 x 10” C-CAM
®
long throw subwoofer driver.
Dimensions:- Cabinet: 320 x 320 x 330mm
(H x W x D) 12 5/8 x 12 5/8 x 13 Inches
336mm High Inc feet
13 1/4 Inches High Inc feet.
Weight (unpacked):- 10.92Kg (24lbs)
Input Impedance: - 20K Ohms
Mains input voltage:- 110 - 120 Vac 50/60Hz
220 - 240 Vac 50/60Hz
(Factory Pre-set)
C-CAM
®
is a registered trade mark of Monitor Audio Ltd
TROUBLE SHOOTING
Should you experience any technical, or set-up problems with your subwoofer please check the
Trouble Shooting Guide below:
My subwoofer will not turn on/no power.
• Is the LED illuminated on the back of the unit? If not, then check your mains lead is
properly connected both at the subwoofer and at the mains outlet. Also check the fuse of
the mains plug (where fitted) and also the fuse in the subwoofer. See page 4 & 6 for further
information on changing the fuse and it’s location.
• Is the LED on the back red? If so, you have power going to the unit. It could be that there
is no signal, or the 12v trigger is connected and the source not turned on (see below).
• Have you got the 12v trigger connected? If so, the subwoofer will not power up until the
source is powered up.
• Has it got a signal going to it (12v trigger not being used)? If so, is the Power Mode Switch
in the Auto or On position, and the signal source is turned on? Try adjusting the volume
level of the source.
If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio
immediately.
No sound from subwoofer.
• Is the LED on the back red or green? If it is red, then the unit hasn’t actually turned on.
See above suggestions. If it is green, then your unit is powered up and turned on. Check
further suggestions below.
• Are the signal leads connected correctly? Check these. If possible, check with a second,
known to be working set.
• Is the volume level just very low?
If it still does not output a signal, please contact your local dealer/ distributor or Monitor Audio
immediately.
Bronze BXW-10
8