Owner's Manual
Table Of Contents
Prior
to
Fitting
the
Controlled
PerfomanGe
Series
Speakers
CAUTION: These Controlled Perfomance loudspeakers can only be fixed into plasterboard (dry-lined) or suspended
ceilings/ walls with a thickness of up to 45mm
(1
314
")
. Solid wall installation will require channeling out and frame
work constructed
to
provide a structure for the
Tri
Grip® dog legs
to
clamp to. For safety reasons, if you are unsure
of your ability to provide a secure and safe fixing, do not attempt
to
fix
these speakers, please obtain the services
of a competent and qualified trades person.
CAUTION: Ensure that there are no water pipes
or
electricity cables running within the wall structure before cutting
the speaker apertures. Work from secure steps and avoid trailing wires.
Over
Tightening
Warning
& ATTENTION INSTALLERS:
Do not over-tighten the Tri-Grip Dog Leg clamps. Over tightening the clamping mechanism on any
in
ceiling/
in
wall speaker
can result
in
damage to the speaker mounting hardware, ceiling/ wall or speaker frame, and/ or deflection
in
the speaker
frame during installation.
If you notice any of the above during installation, you have overtightened the
Tri
Grip dog
leg.
Back off the mounting screw
until deflection
is
reduced to
al
l
ow
the product to sit firmly against the ceiling / wall.
& Do not exceed
5Kgf/cm
(4.34 lbf/inch.) or 0.5
NM
when tightening the
Tr
i Grip dog leg screws.
When are using a cordless screwdriver/ drill
to
install this product ensure the clutch
is
set
to
it's lowest setting
to
avoid from
over-tightening and damaging the mounting hardware.
~
A
".
A
-)
'-
1
I
\ '
\
©
✓
x©
Painting
the
Grilles
& NOTE:
If
choosing
to
paint the grille, we recommend you follow these simple steps:
1.
Remove the membrane scrim from the inside
of
the grille.
2.
Paint
all
grilles required for the installation with the same batch of paint
(if
they are to be the same colour). Spray paint
is
easier to apply or use a stippling action when brushing to avoid blocking the holes of the gril
le.
3.
When
dry,
attach the spare membrane scrim (supplied) into the inside of the gri
ll
e.
4.
Fit
the grille to the speaker
(s)
.