Installation Guide 300 Series
Installation guide 300 Series The 300 Series models utilise RST® bass drivers and a high specification version of the C-CAM® gold dome tweeter. These models offer a higher grade of performance, and greater flexibility. The RST® (Rigid Surface Technology) drivers are more commonly found in our Gold Signature Series. The drivers used are our second generation of our RST®. The cone profile has been further refined using “Finite Element Analysis”, to provide a smoother response and reduced break up.
Installation procedures Painting NOTE: If you are choosing to paint your 300 Series loudspeaker, we recommend you do this prior to installation by following these simple steps: 1. 2. 3. 4. Remove the membrane scrim from the inside of the grille (do not fit grille to speaker frame). Place paint mask over the speaker baffle. Paint both the frame and the grille at the same time and with the same batch of paint (if they are to be the same colour).
C380-LCR C380-FX C-CAM® RST® IDC C-CAM® RST® Tri-Grip H.F Boundary Di-Pole H.F Tri-Grip W380-LCR C-CAM® RST® IDC H.F M.F Boundary Tri-Grip Frequency Response 45 Hz - 30 KHz Frequency Response 45 Hz - 30 KHz Frequency Response 42 Hz - 30 KHz Impedance (nominal) 6 Ohms Impedance (nominal) 6 Ohms Impedance (nominal) 6 Ohms Sensitivity (1W@1M) 90 dB Sensitivity (1W@1M) 90 dB Sensitivity (1W@1M) 90 dB Maximum SPL 112 dBA Maximum SPL 111.
