User manual

- 14 -
9.3 Video/TC Header Pin-out descriptions (JP2)
The pins on the Video/TC header are as described below:
Figure 7 - Video/TC Header Pin-out
When the Video/TC Header is used, be sure to not terminate twice the CVS1IN input. Use only either the termination on the
Mykerinos board (JP4 or software) or the one provided on the Video/TC Header.
Note that CVS2IN is not available on the Mykerinos board since November 2004 (MB1 S/N 12600 - … and MB5 S/N 16150-16759
and 16803 - …).
Here is a representation of the Video/TC bracket:
Figure 8 - Video/TC bracket
Terminology:
CVS: Composite Video Signal, NTSC, PAL or HDTV.
LTC: Longitudinal Time Code, either SMPTE or EBU.
VITC: Vertical Interval Time Code, either SMPTE on NTSC or EBU on PAL.
SCL, SDA: Serial clock and Serial Data for I2C serial communication
Spare 2
ASC Out
TXD
Spare 1
GND
CVS Out
LTC Out
SCL
ATC Out
500mA fused +5v
RXD
GND
CVS2/WCLK In & Out
CVS1 In
LTC In
SDA
PCB
Component side
CVS Out
CVS In 1
Wordclock In & Out (Old
CVS2In)
LTC In
LTC Out
Header 1
Header 2
Jumpers
16-pin
ribbon cable