User manual

- 2 -
Please read the following information very carefully before attempting any installation. Failure to comply with the precise
instructions may result in damage to your Merging hardware. Please read this entire section of the manual carefully before.
1 Important notice
1.1 STATIC DANGER NOTICE:
Please note that the Mykerinos/-X board contains delicate electronic components that can be damaged or even destroyed
when exposed to static electricity. Take all necessary precautions not to discharge static electricity when touching any of the
Mykerinos/-X components.
1.2 INFORMATION FOR THE USER:
Mykerinos/-X and its daughter card comply with the following specifications:
EMC Emissions
EN 55022 : 1994 /A1 : 1995 /A2 : 1997 Class A ITE emissions requirements (EU)
FCC 47 CFR Part 15 Class A emissions requirements (USA)
EMC Immunity
EN 50082-1: 1992 EMC residential, commercial and light industrial generic immunity standard.
FCC Notice
This product has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.
These limits are designed for providing reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions contained in
this manual, may cause harmful interference to radio and television communications. However, there is no guarantee that interference
will not occur in a particular installation.
NOTE: Connecting this device to peripheral devices that do not comply with CLASS A requirements or using an unshielded
peripheral data cable could also result in harmful interference to radio or television reception. The user is cautioned that any changes
or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment. To ensure that the use of this product does not contribute to interference, it is necessary to use shielded I/O cables.
CE Notice
Such a marking is indicative that this system’s devices meet the following applicable technical standards:
• EN 55022 – “Information Technology Equipment - Radio disturbance characteristics Limits and methods of measurement”
• EN 50082-1: 1992 – “Electromagnetic compatibility – Generic immunity standard Part 1:Residential, commercial, and light
industry”
This product is classified for use in a typical Class A commercial environment, and is not designed or intended for use in other EMC
environments. The user of this product is obliged for proper use and installation of the product and for taking all steps necessary to
remove sources of interference to telecommunications or other devices.