Speaker User Manual

Front Panel Switches
Monopole/ Dipole Switch.
This switch determines the actual
mode of the GS FX. When used
in a 5.1 system as rear speak
-
ers, set the switch to monopole.
If they are used in a 7.1 system
as side speakers set the switch
to dipole. If you are using 4 GS
FX’s (side and rear) set them all
to dipole mode. Please see the
illustrations on pages 7 & 8 to
determine what position the
‘Location Switch’ needs to go
in depending on system set up.
If you are using the 12v
trigger, set the switch to
monopole mode. The trigger will
switch a relay to enable the di-
pole mode.
Location Switch.
This switch is used to determine
the location of your GSFX’s.
Please refer to the illustrations on
pages 7 & 8 for correct
positioning. This will only make a
difference when the Monopole/
Dipole switch is set to ‘dipole’
mode.
Tweeter Attenuation Switch.
This switch adjusts the level of
the main high frequency tweeter
unit. In the middle position there
is no attenuation. Place it in the ‘-‘
position and the high frequencies
will be attenuated by 3dB. Place
it in the ‘+’ position and the high
frequencies will be boosted by 3dB.
© Monitor Audio Ltd 2005
V2
6.