User's Manual

4
Remote
1. Standby
Used to put the ASB-10 in and out of stand by
mode.
2. Volume Up
Used to increase the volume of the ASB-10.
3. Previous Track
Used to select the previous track of the audio
source.
4. Volume Down
Used to reduce the volume of the ASB-10.
5. Mute
Used to mute the sound from the ASB-10. Pressing
it again returns the volume to the previous level.
6. 3D Sound
Used to change the sound of the ASB-10 to create
a 3 dimensional effect (refer to page 16).
7. OK & Play/ Pause
Used to confirm a selection when in the menu and
also used to play/ pause the audio.
8. Next Track
Used to select the next track of the audio source.
9. Input Toggle
Used to toggle through the various analogue and
digital inputs.
1 6
7
8
9
2
3
4
5
1. Holding the remote in your hands with the buttons
facing up, pull out the draw in the bottom of the
remote.
2. Completely remove the drawer to reveal the
battery.
3. Replace only with the same type, CR2025 3v.
4. Slide the drawer back into the remote.
Changing the Remote Battery