Instruction manual

Spiked Foot Fixing For Wooden/Hard Floors

(Silver RS5,RS6 & RS8 only)

For use on solid floors or where spikes are

inappropriate, it is possible to use the foot

without the spike insert. To use the foot in

this manner carefully grip the knurled

portion of the spike and rotate anti

clockwise to unscrewthe spike fully.

You may find it easier to first remove the

polymer pad so as to gain more purchase

on thespike.

Thepad shouldbe replacedbefore carrying

out the levelling operation previously

described.

Connecting Your Silver RS Loudspeakers

You will notice that when you unpack your loudspeakers, there are plastic

terminal caps in the terminals where the speaker cable connectors should go.

These can besimply removed by placing a thin, flatobject underneaththemand

carefully leveringthemfree.

All of the Silver RS Series loudspeakers (except the RS FX, see page 9) can be

either single or bi-wired/bi-amp. Monitor Audio always recommends bi-wiring

your loudspeakers for improved sound quality. You will also need to run your

speakers in for approximately 60 hours before they perform at their optimum

capability.

If you are going to be connecting your speakers in a bi-wire, or bi amp format,

please remove the terminal links. Do this by unscrewing the red and black

terminals slightly and removing the link. Connect the speaker as in the

illustrations on page 14.

You can also bi-amp your loudspeakers. This is carried out in the same way as

bi-wiring except instead of using one amplifier to power all of the drive

units/tweeter in the speaker; you are using one amplifier to drive the treble

(tweeter) and the other amplifier to drive the mid/bass sections. If you are

intending to do this, please consult your local hi-fi dealer for their

recommendations foramplifierrating.

We recommend the use of our Pureflow

loudspeaker cable to get the best from

your speakers. Further informationcan be foundat www.monitoraudio.co.uk