Instruction manual

6
© Monitor Audio 2005 RS Rev 5
Your Silver RS6
A svelte 2 ½ way floor-stander, the RS6 builds on the considerable musical
strengths of the RS1 and RS5 by providing greater bass extension and weight.
Rigid construction is again key to achieving the clean, un-boxy sound. The RS6
employs multiple bracing positioned at critical resonance nodes. The two 6 inch
C-CAM
®
drivers have been designed specifically for the RS6. The lower unit
handles bass only, the other provides punchy upper bass and a clear, natural
mid-band right up to the crossover point with the tweeter at 3KHz. The RS6 has
a reflex port at the rear as well as the front. This is to provide maximum airflow
at low frequencies and reduces air pressure that can lead to bass compression
effects.
To remove the grille, carefully prise it away from the cabinet sections at a time.
There are three sets of fixing points on this product. One above the mid-bass
drive unit, one below it and the third below the bass drive unit. Refitting is the
opposite of removing. Ensure itis correctly orientated.
Tosafely fit theplinth and spikesplease refer to pages 12 and 13.
For information on wiring and system configurations, please refer to pages 13,
14 and 15.
Frequency
Response
(Cross over
Frequency)
Sensitivity
(1W@1m)
Nominal Impedance
(Ohms)
Power Handling
(W) RMS
Recommended
Amplifier power
output.
(W)RMS
38Hz –30KHz
(3KHz)
91dB 6 120 40 – 120
Drive Unit
Complement
Cabinet
Design
Product External
Dimensions.
cm (inch)
Plinth
Dimensions
(foot print)
cm (inch)
Weight
Kg (lb)
Finishes
1 x 6" C-CAM
®
Bass, 1 x 6" C-
CAM
®
Bass/ mid-
range. 1 x 25mm
Gold Dome C-
CAM
®
tweeter.
Front & rear
ported, bass
reflex
85H x 18.5W x 25D
(33
7
/
16
" x 7 ¼ "
x 9
13
/
16
")
2.5H x 25.5W x
30.5D
(1" x 10" x 12")
18Kg
(40)
Black Oak,
Rosenut, Walnut,
Natural Oak or
Cherry real wood
veneer. All fitted
with Black Grille