verw-12 owners manual
Contents Contents- - - - - - - - - - - Connected to an AV Receiver- -9 Introduction__________ Connected to a Stereo Amplifier__g Spiked Foot Assembly_ _ _ _ _ _ _ 2 For Carpeted Floors 2 EO Profiles 10 Additional Information for Auto On/ Off and Spiked Foot Fixing For Wooden/Hard Signal Sensing 10 Room 2 Specification 11 Amp Panel 3 Trouble Shooting 12 Top Control Panel 6 Initial Set Up 7 Factory Reset 12 Power Cycle 7 Firmware Version 12 Set Up 8 Owner Information 13 Autom
Spiked Foot Assembly For Carpeted Floors The Silver spiked foot assembly incorporates a spike for use on carpeted floors and also, a soft polymer pad (for use on wooden or tiled floors). ~ Please ensure there are no hidden wires under the carpet that could be damaged by the spikes. The foot comes fully assembled for use on carpeted floors. All that is required is fixing into the bottom of the cabinet. This Locking Nut _ _......,...
Amp Panel @ 1 "",.. .• • FREQUENCY :@: @ ,.. "" PHASE o· @ Mm~~!!~~ ~~~}0~ 0 Hz 2 @ @ • 120 40 • © © © © 1so· Silverw-12 3 "" - POWER MODE 4 ...,.. TRIGGER ON @ AUTO 0 & II .lf!UII!Il~··!\'~1.-- RISQUE DE CHOC I:LECTRIOUE 5 @ @ © ...,.. NEPASOUVRIR I • REF~O~~i~;gl~~~~~~~:~R~~~~g~NEL AITENTION: AFIN Of RI:OUIRE TOUT RISQUE DE CHOC I:LECTRIQUE , NE PAS RETIRER LE COUVERCLE (O~e~:~~te~R~~~Etu~7LTs~~~~~~~~~~~~ ~~3~ 6 7 "" ,..
Type of Main Speaker Crossover Control Setting Large floor-standing speaker 40-60Hz Small floor-standing speaker 50-70Hz Large stand-mount/ bookshelf speaker 50-80Hz Small stand-mount/ bookshelf speaker 60-90Hz Small satellite speaker 80-120 Hz 2. Phase Control Switch The Phase Control is used to synchronise any delay between the SilverW-12 and main/ satellite speakers. When the Silver W-12 is in phase with the main/satellite speakers the sound should be full bodied.
7. RCA Line Level Outputs (Stereo Left & Right) To be used to feed additional sub-woofers to the W-12 by 'daisy chain' type connection. The outputs are link out only connections and do not provide any form of filtering. 8. LFE Input (RCA Type) This input is to be used when connecting the W-12 to an AV amplifier/ receiver. When using the LFE input, the crossover control is not used.
Top Control Panel 1 2 3 4 EO Button 1. This button has multiple functions, these are listed below: • It wakes the W-12 from standby with a single press • A long press (5 seconds) puts the W-12 into standby mode. • When operational, it cycles through three different EO profiles. • The LED indicates selected EO profile (while operational) and other states depending on mode and colour. A colour matrix can be found below.
4, Volume Control This is used to set the volume control of the sub-woofer. Adjust this to a level at which the sub-woofer blends seamlessly into the rest of your system. See the Set Up proceedure on page 9 for recommended initial settings. Initial Set Up ~ Leave the Silver W-12 unplugged from the mains until all signal cables ~ are connected. The W-12 should now be sited in the most suitable position, preferably not directly in the corner of a room as this may cause excessive bass boom.
Set Up Automatic Position Correction Automatic Position Correction (APC) will optimise the acoustic output of the subwoofer to match the ideal system performance by removing the dominant room modes from the listening position. The APC will take measurements from 3 different seating locations within the room to achieve the most accurate correction. NOTE: Please run the APC before running the automatic room set up of your AV amplifier. To perform APC, follow the steps listed below: 1.
Connected to an AV Receiver The majority of AV amplifiers have automatic setup systems. If your amp has an auto set up procedure, run this now with the volume set to around 10- 12 o'clock, and the power mode switch in the On position. When the auto·set up is complete check the settings on the AV amp for the sub woofer to ensure they are correct. The crossover frequency should be roughly the same as in the table on page 4 and the level should be no more/ less than+/- 3dB.
EO Profiles The Silver W-12 has 3 preset EO profiles. These are EQ1 (Movies), EQ2 (Music) and E03 (Impact). These profiles change the characteristics of the sound from the subwoofer. We highly recommend experimenting with the different profiles to see which most suits your room, tastes, environment, etc. An example of the different profiles do can be seen below: Silver W12 EQ Profiles :.
Specification System Format 25mm with Cabinet Sealed construction with internal bracing Low Frequency Response ~OHz {Typical IEC room } M.D.
Trouble Shooting Fault Mode The Silver W-12 can display 3 individual faults codes. Each fault mode makes the LED in the EQ Button alternate between yellow and another colour; red, green or blue. Mode 1 - Power supply unit issue Yellow/Red flashing Mode 2 - Power amplifier issue Yellow/Green flashing If these faults occur, try carrying out a power cycle first, leaving the mains power removed for at least 5 minutes. If that doesn't solve the error try a factory reset.
Owner Information Product Details Model: Silver W-12 Product Serial No: - - - - - - - - - - - - Amp panel Serial No: _ _ _ _ _ _ _ _ _ _ __ Date of Purchase: ------------- Dealer Details Dealer Name: - - - - - - - - - - - - - - Address: _ _ _ _ _ _ _ _ _ _ _ _ _ _ __ Post code: ---------------- E-mail address: -------------- Monitor Audio reserves the right to alter specifications without notice.
Monitor Audio Ltd. 24 Brook Road Rayleigh, Essex SS6 7XJ England Tel: +44 (0)1268 7 40580 Fax: +44 (0)1268 740589 Email: info@monitoraudio.co.uk Web: www.monitorau dio.com Designed & engineered in the United Kingdom, made in China Version 1 .
MONITOR AUDIO" design for sound IMPORTANT SAFETY INSTRUCTIONS GB - SAFETY INSTRUCTIONS FR - CONSIGNES DE SECURITE IT- ISTRUZIONI PER LA SICURE.
WARNING • TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE • TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE • TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE PLUG TO WIDE SLOT AND FULLY INSERT.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen onto the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped. IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. 3. Keep these instructions. Heed all warnings. 4. Follow all instructions. 5. 6.
RE-CYCLING Correct Disposal of Waste Electrical and Electronic Equipment (WEEE) by User in Private Households in the EU. This symbol on the product or accessories indicates that they must not be disposed of with your household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
GUARANTEE AND SERVICE CLAIMS UNDER THIS GUARANTEE To validate your warranty please visit www.monitoraudio.com within 30 days of purchase. The equipment should be returned in its original packaging to the original supplier where possible, or to any other authorised Monitor Audio dealer. If it is not possible to return the equipment by hand, then it should be sent carriage prepaid via a reputable carrier. If the original packing is not available replacement packaging can be purchased from Monitor Audio.
EN61 00-3-3: 01.95 Electro magnetic compatibility (EMC) - Part 3: Limits- Section 3: Limits of voltage fluctuations and flicker in low-voltage supply systems for equipment with rated current up and including 16 Ampere per phase. EC Declaration of Conformity We, Monitor Audio Ltd. 24 Brook Road Rayleigh Essex SS6 7XJ England Signedby: ·12 Declare in own responsibility, that the Monitor Audio products described in this manual is in compliance with Technical Standards/ Council Directives: ~ Name:· D.S.
m MONITOR AUDIO® monitoraudio.com Monitor Audio Ltd. 24 Brook Road Rayleigh, Essex SS6 7XJ England Tel: +44 (0)1268 740580 Fax: +44 (0)1268 7 40589 Email: info@monitoraudio.co.uk Web: www.moni toraudio.co m Designed in the United Kingdom © 2012.
