Owner's Manual

Connected
to
an
AV
Receiver
The majority of
AV
amplifiers have automatic setup systems.
If
your amp has
an
auto set
up procedure, run this
now
with the volume set
to
around
10-
12
o'clock,
and the power
mode switch
in
the
On position.
When the auto·
set up
is
complete check the settings on the
AV
amp for the sub woofer
to ensure they are correct. The crossover frequency should be
roughly the same as
in
the
table
on page 4 and the
level should
be no more/
less
than+/-
3dB.
If
not we
would
suggest adjusting accordingly.
Now
play
a variety
of
music/
film
excerpts that you are
familiar
with
gradually
increasing
the
volume
to
an
average
listening level
once you are sure everything
is
working correctly.
Connected
to
a
Stereo
Amplifier
Stereo L
&
R input may be required if using a 2-channel stereo
amplifier, or
an
amplifier
with no
LFE
output. Connect 2 x interconnect
cables (left and right) from
an
amplifier
to
connections marked Inputs
L
&
R.
With the pre/ integrated
amplifier
set to a
low level,
set the subwoofer up using the
suggested guide below
before
playing any music/ test tones.
•
Set the
volume to around
10
o'clock
(Page
6)
•
Frequency should
be set
in
accordance to your main speakers (refer to the
table
on
Page
4)
•
Phase
to
0 (Page
4)
Now
play
some
familiar
music and
gradually
adjust the
volume
and/
or the frequency
until
happy with the integration and
balance
of
the sub woofer with the rest
of
the system.
9