Owner's Manual

7.
RCA
Line
Level
Outputs
(Stereo
Left
&
Right)
To
be used to feed additional sub-woofers
to
the W-12 by 'daisy chain' type
connection. The outputs are
link out only
connections and
do
not provide any form
of filtering.
8.
LFE
Input
(RCA
Type)
This input
is
to be used when connecting the W-12 to
an
AV
amplifier/
receiver.
When
using the
LFE
input, the crossover
control
is
not used. This
is
due
to
the crossover
function being controlled and set by the
AV
amplifier/ processor when it's set up
procedure
is
run.
9.
LFE
Output/
Link
(RCA
Type)
To
be used to feed additional sub-woofers
to
the W-12 by 'daisy chain' type
connection. The output
is
a
link
out only connection and does not provide any form
of filtering.
10.
Mains
Power
Switch
The Mains Power Switch should be switched to the
'Off' position when the
Silver
W-12
will not be used for extended periods. The switch must be
in
the 'On' position
for the subwoofer to function.
WARNING:
Due
to
the mains switch being located on the rear
panel,
the apparatus
must be
located
in
the open area with no obstructions to access the mains switch.
11.
IEC
Mains
Power
Connector/
Fuse
Location
The Silver
W-12
is
supplied with a two-pin
mains· input socket for connection
to
the
mains
supply. Use ONLY the appropriate
IEC
mains
lead provided with the product.
Also
fitted
is
an
external
mains fuse.
If
a fuse blows
during operation a spare fuse
is
provided within the fuse holder
for replacement. If
you wish to change the fuse, you
can
do
this by removing the
IEC
mains
lead
and carefully levering out the original fuse
from its
holder below
the
IEC
mains input socket
(11
a).
If
the fuse blows again it
is
advisable to seek
help
from
an
authorised service agent.
DO NOT attempt to re-fit a
further fuse as this
could result
in
serious damage to the
amplifier unit.
5