Owner's Manual

Top
Control
Panel
1
2
3
4
1.
EO
Button
This button has
multiple functions, these are listed below:
•
It
wakes the W-12 from standby with a
single press
•
A
long
press
(5
seconds) puts the W-12 into standby mode.
•
When
operational,
it
cycles through three different
EO
profiles.
•
The
LED
indicates
selected
EO
profile (while operational)
and other states
depending on mode and
colour. A colour
matrix can be found
below.
WHITE
-
BLUE
PINK
GREEN -
CYAN
RED
Boot sequence
EO
Profile 1 (Movies)
EO
Profile
2 (Music)
EO
Profile
3 (Impact)
Room
Calibration
In
Progress
Factory Reset (Static)
YELLOW
&
OTHER
COLOUR-
Fault
mode (when flashing
with other
colour. See
below.)
Further information on the
EO
profiles
can be found on page
10.
2.
Calibration
Button
The
calibration button is used
to
enter 'Automatic Position Correction
(APC).
This
is
used
to
take SPL measurements
of
the room and
to
correct the frequency response
of
the speaker
to
offset any colouration
effects of the environment.
Refer
to
page 8 for further information on running the APC.
3.
Microphone socket
Used
to
set the sub woofer up
to
adjust for the room acoustics.
Refer
to
page 8
6