Owner's Manual

4,
Volume
Control
This
is
used to set the
volume control
of the sub-woofer. Adjust this
to
a
level at
which the sub-woofer
blends seamlessly
into the rest
of
your system.
See
the Set
Up
proceedure on page 9 for recommended
initial
settings.
Initial
Set
Up
~
Leave the
Silver
W-12
unplugged
from the mains
until all signal cables
~
are connected.
The
W-12
should
now
be sited
in
the most
suitable
position, preferably not
directly
in
the corner
of
a room as this may cause excessive bass boom.
Once a desirable
position
is
achieved it
is
important
to
check if the
cables are
long
enough
to
reach comfortably
without being under tension.
Cables should be less
than
10
metres
to
avoid interference.
~
Never connect or disconnect the RCA input/ output leads
with the
Silver
~
W-12
switched on.
For
initial
setting up, put the Power
Mode
Switch
in
the
'On'
position and
leave
the 12v
trigger cable disconnected.
Once
the input (and output if necessary) cables are connected and the power mode
switch is
in
the
On position, the W-12 can be connected
to
the mains power
supply
and
switched on at the mains power switch.
Power
Cycle
When the W-12 powers
up
for the first time or when it has been turned off for a
long
period, the
EO
button
will flash
red 3 times while powering up and then
go
in
to
standby
mode
(if
power mode switch
is
in
the auto position).
When it senses a
signal
or
is
activated by the 12v trigger, the LED will illuminate
white
while
booting and then the
colour of the
previously sleceted
(or
default)
EO
profile.
If
the power mode switch
is
in
the
On
position it will
be white
while
booting up and then
to
the
colour
of
the previously selected
(or default)
EO
profile.
To
continue with the set
up
procedure, put the power
mode
switch
in
the
'On'
position
so that the
APC can be initiated.
7