Specifications

MONITOR HEATING SYSTEMS
Section 2: Installation
2-5 FUEL TANK REQUIREMENTS
WARNING:
INSTALLATION OF ANY REMOTELY LOCATED
FUEL TANKS MUST COMPLY WITH ALL LOCAL
STANDARDS AND/OR BUILDING CODES.
Heater fuel (crystal clear kerosene only) can be
stored in remotely located storage tanks ranging
from 55 gallon drums to 275 gallon tanks. When
using large tanks a pressure regulator with a max. of
2.5 PSI should be installed near heater inlet,
(if top of tank is going to be 8' higher than base of
unit.)
/JK.CAUTION: In some installations, it may be bet-
ter to install permanent fuel tank
plumbing. A licensed plumber or
oil dealer should do this.
2-6 TEMPERATURE SENSOR WIRING REQUIRE-
MENTS
A wall-mounted temperature Sensor gauges room
temperature and automatically regulates the heating
cycles of the Monitor System.
The standard sensor wire is 4/£' long and can be
left mounted on the back of the cabinet as shipped.
If this is not practical the sensor can be mounted on
a wall.
il\CAUTION: If sensor is to be mounted re-
, motely be careful not to place it in
direct sunlight, on uninsulated
exterior walls in drafty areas etc.,
as this will create an inaccurate
temperature reading.
2-7 BUILDING CODES
Fire regulations, electrical and other local building
codes may govern the installation and use of a
vented heater and related fueling systems. Prior to
installation, check and comply with all codes.
2-8 UNPACKING
Save all shipping materials until the Monitor has
been completely installed and is working properly.
A. Cut the three plastic ribbons that hold the ship-
ping carton together.
B. Remove the top.
C. Remove from the shipping carton the Cardboard
(drilling) Template and the Owner's 'Guide.
NOTE: The Dealer should complete the Registra-
tion Card at time of customer purchase and
return it to Monitor Products, Inc. as soon
as possible.
D. Remove the spill tray from shipping carton, and
remove the plastic bag.
E. Remove the plastic bag covering the heater.
F. Remove the plastic bag containing the heater
parts.and set it aside.
G. Remove the Flue Pipe from the rear of the
heater. When ready to install, separate Flue
Pipe from cardboard packing materials.
H. Firmly grasp cabinet handles (one of each side
of heater cabinet) and lift heater off the card-
board shipping base.
I. Check for parts as listed in Monitor Owners
Guide.
IMPORTANT: Only the standard-size Flue Pipe
is shipped with the heater. The
Monitor dealer will also stock a
longer Flue pipe B and a Relay
pipe, Window Kits, Extension
Kits, and other accessories that
may be required for non-standard
installations.
12