Specifications
MONITOR
HEATING
SYSTEMS
Section
3:
Operation
ITEM
NO
CONTROL
OR
INDICATOR.
FUNCTION
Iteml
5
SELECT
push-button switch
This switch will
be
used
for the
selection
of the
DAY
SET,
CLOCK
SET, TIMER
SET and
also
for
the day of the
week
(Mon,
Tue, Wed, Thu,
Fri, Sat, Sun).
Iteml
6
TIME
push-button
switch
This switch
is
used
to set
time
and
change
display over.
TEMP push-button
switch
This switch
is
used
to set
temperature
and
change display over,
in 2
degree increments.
Iteml
7
HOUR/DOWN
MINUTE/UP
repetitive-action
push-button switch
Programs time
or
temperature.
NOTE: Each time push-button switch
is
pressed,
the
digit advances
in
incre-
ments
of one
digit,
If
push-button
is
pressed
and
held,
the
digits
are ad-
vanced
repetitively.
Iteml
8
SET
push-button switch
"Sets" time
and/or
temperature.
If
this
control
is not
pressed
after
time
and/or
temperature have been programmed,
the
time
and/or temperature programmed
(as
indicated
by
display window) will
not be
accepted,
and
will
revert
to
previously programmed time
and/or
temperature.
Iteml
9
CLEAR
push-button switch
Erases
any
programmed time
and
tempera-
ture.
When cleared, time
and/or
temperature previ-
ously programmed
and
displayed disappear(s)
from window.
IMPORTANT:
Both current time
and
current
day
of the
week
will
have
to be
reprogrammed
if
electrical
op-
eration
is
interrupted
by
power
failure
or by
disconnecting
heater
plug from wall outlet
beyond
30
minutes.
If
this
oc-
curs,
the
heater will
go
into
MANUAL
mode
of
operation.
Item20
ON/OFF
push-button
switch
ON
position
(push-button
is
"in") applies
power
to
the
unit.
When this
occurs,
the
OPERA-
TION indicator
light
to
Indicate that heater
op-
eration
has
begun.
OFF
position
(push-button
is
"out")
remove
power from
the
heater.
All
circuits-except
for
Clock
and Air
Flow
— are
shut down.
32