Instructions

TROUBLESHOOTING
Problem: I am moving the slider, but the reading is not changing.
Solution: Make sure that the analog read pin block has the same pin selected as is
physically connected to the Slider for micro:bit's output.
Problem: The amber power LED on the Slider for micro:bit is not lit.
Solution: Make sure that your micro:bit itself is receiving power and that the GND
and 3V connections of the micro:bit are connected to the GND and 3V connectors
of the Slider.
Problem: How can I connect more than one Slider for micro:bit to my micro:bit?
Solution: You can use any of the micro:bit's pins to read analog values, so to use a
second micro:bit you just need to supply it with power and connect its output to an
otherwise unused pin as shown below. Note that you will need some more alligator
leads.
Page 13