Instructions / Assembly

Step 4: Using the level, ensure that the bracket is vertically level and pre-drill a 2” deep hole in

the second oval-shaped mark. Tighten the screw in the second hole.

Step 5: Find another stud the same height for the opposite mounting bracket. If the included

Bar is 50” you need to ﬁnd a stud that is about 48” away from you ﬁrst bracket, if your bar is

35 inches you will need to ﬁnd a stud that is about 32” from the ﬁrst bracket.

Step 6: Once one mounting bracket is secured to the wall, place the push button side of the

bar into the diamond-shaped hole on the bracket. Slide the hanger bar into the hole and

secure it by depressing the ﬁrst push button and sliding the bar through the hole into the

mounting bracket as shown in Figure 2. Next, slide the other mounting bracket on to the

opposite end of the hanger bar and position it approximately where the opposite stud is

located. Place a level on top of the hanger bar and adjust the unsecured mounting bracket up

and down on the wall until the hanger bar is level. Mark the opposing mounting bracket’s top

oval hole on to the wall with a pencil. Remove the hanger bar.

Step 8: Slide the non-push button side of the hanger bar in the diamond shaped hole on one

of the brackets. Slide the other side of the bar into the opposing bracket as described in step

5 (see ﬁgure 2).

Step 9: The hooks provided in your rack system are designed to hold a variety of items. The

“J” hook is designed to hang either down, or perpendicular to the wall. All other hooks hang

perpendicular. By placing the shorter hooks backwards on the bar you can hang items in the

back space as well. Determine which hook will best hang your items, by utilizing the smallest

hook that will work. Position items used the most where they are most accessible.

Step 10: For hanging hooks on the hanger bar See Figure 3 (as seen from underneath.) The

hooks will snap on lightly allowing you to securely hang each item on a hook. 3” hooks may

also be placed backwards toward the wall, this only applies to kits equipped with 3” hooks.

Step 7: Repeat steps 2 through 4 for the opposite mounting bracket.