Instructions / Assembly
ASSEMBLY INSTRUCTIONS
WHAT YOU WILL NEED:
stud finder, level, power drill, 3/16” drill bit, pencil, hammer, and a nail.
READ ALL INSTRUCTIONS BEFORE INSTALLING THIS PRODUCT
Congratulations and thank you for purchasing the Monkey Bar Storage Rack®, the most heavy-duty, cutting
edge system for garage organization in the world. We know you will be satisfied with this product. For more
information about this product and other products oered by Monkey Bars®, go to www.MonkeyBarStorage.com.
SAFETY INSTRUCTIONS
PLEASE USE CAUTION WHEN INSTALLING THIS PRODUCT. INSTALLATION INVOLVES THE USE OF POWER TOOLS, DRILL-
ING, HAMMERING AND OTHER POSSIBLE HAZARDS.
• See your power tool safety instruction manual for proper use of your power tool before attempting to install this product.
• Use eye protection when drilling.
• Be sure to check for electrical wiring inside the selected wall before attempting to drill.
!!
Figure 1 Figure 2 Figure 3
Step 1: Using a stud finder, locate a stud in the wall where you would like to install the mount-
ing bracket. Make sure it is high enough to get all items o the floor. Mark with a pencil the
location of the top oval shaped hole.
Step 2: Lightly tap a nail into the location determined by the stud finder to verify that a stud is
where the stud finder says it is. Using a 3/16” drill bit, drill a hole approximately 2 inches deep
in the oval-shaped mark on the wall. MAKE SURE THAT YOU DRILL INTO THE CENTER OF
THE STUD OR ELSE THE BRACKET WILL NOT BE FULLY SECURED INTO THE WALL.
Step 3: Align the mounting bracket over the drilled hole and tighten the screw with a Phillips
screw driver. DO NO OVER TIGHTEN THE SCREWS, it will only need to be snug. See Figure 1.
(The mounting bracket is reversible- as seen by the dashed lines in Figure 2- so that the brack-
et can be accommodated to virtually any width of studs withing the reach of the hanger bar.)