Installation Guide

This product comes complete with trilingual installation, operating, care and maintenance instructions. Dimensions are subject to manufacturer’s tolerance and can change
without notice. Distributed by Ferguson and Wolseley Canada.
CAP 07/2015
Decorative Accessories
|
DRAIN REPAIR
Trap Body
Trap Bottom Nut
Wall Flange
Pipe
Contemporary Bottle Trap Installation instruction
INSTALLATION
• Check the pop-up drain is correctly installed to the lavatory according its instructions.
• Remove the inlet nut from the trap body and check the poly washer is inside the inlet nut.
• Slide the tailpiece into the trap body. To ensure a proper compression fit, the tailpiece must
be inserted at least 1” (2.5 cm) inside the inlet nut
• With the threads facing down, slide the inlet nut down with poly washer onto the tailpiece and
hand-tighten the inlet nut until the nut is flush against the trap body.
• Remove the outlet nut from the trap body. Ensure the poly washer is inside the outlet nut.
• With the threads of the outlet nut facing toward the trap body, slide the outlet nut with poly washer
onto the pipe. Be sure to utilize the poly washer and the pipe must be inserted inside the trap body.
• Hand-tighten the outlet nut until the nut is flush against the trap body.
• Slide the wall flange onto the free end of the pipe and insert the pipe then adjust the wall flange to
cover the drain stub out.
• Turn on the water supply to let water run through the drain for checking leaks.
ITEM FINISH
MB139512 Chrome Plated
MB139527 PVD Brushed Nickel
Product Numbers