Technical Specifications

Composition: Monogram siding products are produced using CertaVin™ custom-formulated PVC resin. This resin is
produced exclusively by CertainTeed, allowing CertainTeed to maintain the high quality of its siding products.
Technical Data: Monogram siding is in compliance with ASTM specification for Rigid Polyvinyl Chloride (PVC) Siding ID
3679, and the requirements of section R703.11 of the International Residential Code, and section 1405.14 of the International
Building Code. Monogram siding meets or exceeds the properties noted in Table 1.
ASTM E 84
Meets Class 1 flame spread requirements as tested according to ASTM E84.
ASTM D 1929
Self-ignition temperature 813°F
ASTM D 635
Material is self-extinguishing with no measurable extent of burn when tested in accordance with this specification.
NFPA 268
Radiant Heat Test - Ignition Resistance of Exterior Walls - Conclusion that CertainTeed met the conditions for
allowable use as specified in section 1406 of the International Building Code.
Important Fire Safety Information: When rigid vinyl siding is exposed to significant heat or flame, the vinyl will soften,
sag, melt or burn, and may thereby expose material underneath. Care must be exercised when selecting underlayment
materials because many underlayment materials are made from organic materials that are combustible. You should ascertain
the fire properties of underlayment materials prior to installation. All materials should be installed in accordance with local,
state and federal Building Code and fire regulations.
Wind Load Testing: CertainTeed Monogram double 4" siding has been tested per ASTM D 5206 standard test method for
resistance to negative wind load pressures of 86 psf, which equates to more than 258 mph (V
ASD
) and 300 mph (V
ULT
), per
VSI windspeed calculation guidelines, when installed with nails positioned 16" on center. Check with your local building
inspector for wind load requirements in your area on the type of structure you are building.
Documents: CertainTeed Vinyl Siding meets the requirements of one or more of the following specifications.
Texas Department of Insurance Product Evaluation EC-11
Conforms to ASTM Specification D3679
Florida BCIS Approval FL1573
ICC-ES Evaluation Report ESR-1066
For specific product evaluation/approval information, call 800-233-8990.
Installation: Prior to commencing work, verify governing dimensions of building, examine, clean and repair, if necessary,
any adjoining work on which the siding is in any way dependent for its proper installation. Sheathing materials must have an
acceptable working surface. Siding, soffit and accessories shall be installed in accordance with the latest editions of
CertainTeed installation manuals on siding and soffit. Installation manuals are available from CertainTeed and its
distributors.
Warranty: CertainTeed supports Monogram siding products with a Lifetime Limited Warranty including PermaColor
Lifetime Fade Protection to the original homeowner. The warranty is transferable if the home is sold.
Technical Services: CertainTeed maintains an Architectural Services staff to assist building professionals with questions
regarding CertainTeed siding products. Call 800-233-8990 for samples and answers to technical or installation questions.
Sample Short Form Specification: Siding as shown on drawings or specified herein shall be Monogram Vinyl Siding as
manufactured by CertainTeed Corporation, Valley Forge, PA. The siding shall have a .092" thick nail hem. Installation shall
be in accordance with manufacturer’s instructions.
Three-part Format Specifications: Long form specifications in three-part format are available from CertainTeed by calling
our Architectural Services Staff at 800-233-8990. These specifications are also available on our website at certainteed.com.
CertainTeed Corporation
P.O. Box 860
Valley Forge, PA 19482
certainteed.com
© 01/15