Installation Instructions
3
CHANGE GRIDDLE ORIFICE
(if present)
Locate the 3/4” long griddle orifice. Select the
proper orifice size for your gas and burner from the
conversion chart.
A. Lift off the griddle flue cover. Remove the 2 inside
clamping screws.
B. Lift out the cast-iron grease trough. Slide the
griddle toward the rear and out of the hold-down
tabs along the bottom.
C. Carefully lift and hold the griddle while pulling
additional length of the capillary from the entry
hole. Stand the griddle on end in the grease sump.
D. Remove the 2 hold-down screws at the rear of the
burner.
Pull the burner straight back toward the rear and
out of the gas inlet.
E. Use a 1/2” deepwell socket to remove and replace
the orifice.
Reverse these steps to reassemble the griddle.
Push excess capillary back into the entry hole.
Place the unused orifice in the holder for possible
future use.
Capillary
Front of Range
Griddle Flue Cover
Clamping Screws
Leveling Screws
NOTE: Remove
the 2 screws
positioned on
the inside only.
Do not remove
the outermost
screws—they
are for leveling.
Back of Range
4A
CHANGE MAIN BAKE BURNER
ORIFICE (if present)
Locate the 3/4” long bake burner orifice.
Select the proper orifice size for your gas and burner from
the conversion chart.
A. Remove the oven door and set aside in a safe
location.
B. Remove the 2 oven bottom hold-down screws
from the rear of the cover.
C. Slide the oven bottom forward and set aside.
D. Remove the burner diffuser screw.
E. Lift the front of the burner diffuser up slightly and
slide it forward to disengage the clips at the rear.
Set the burner diffuser aside.
F. Remove the 2 burner retention screws.
G.
Lift the front of the burner up slightly and slide for-
ward setting aside (careful not to damage the igniter.)
H. Use a 1/2” deepwell socket to remove and replace
the orifice.
I. Reverse these steps to reassemble the griddle.
Push excess capillary back into the entry hole.
Place the unused orifice in the holder for possible
future use.
Hold-Down Screws
Oven
Bottom
Diffuser screw
Clips
Burner retention
screws
Burner
2