Installation Guide

49-80512 Rev. 4 
Installation Instructions
INSTALLATION—RECIRCULATING
6
CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
DJURXQGZLUHDJURXQGPXVWEHSURYLGHGE\WKH
LQVWDOOHU:KHQKRXVHZLULQJLVDOXPLQXPEHVXUH
WRXVH8/DSSURYHGDQWLR[LGDQWFRPSRXQGDQG
aluminum-to-copper connectors.
Ŷ5HPRYHWKHVFUHZVRQWKHMXQFWLRQER[FRYHUDQG
the knockout on the top or left side.
Ŷ6HFXUHWKHKRXVHZLULQJWRWKHMXQFWLRQER[ZLWKD
strain relief.
Ŷ&RQQHFWWKHZKLWHOHDGWRWKHEUDQFKFLUFXLWZKLWHOHDG
Ŷ&RQQHFWWKHEODFNOHDGWRWKHEUDQFKFLUFXLWEODFNOHDG
Ŷ&RQQHFWWKHJUHHQ\HOORZOHDGWRWKHEUDQFKFLUFXLW
green lead or bare ground lead.
Ŷ6HFXUHDOOWKHFRQQHFWLRQVZLWKZLUHQXWVRQHDFK
electrical connector.
Ŷ3XVKWKHZLUHVLQWRWKHMXQFWLRQER[DQGUHSODFHWKH
cover. Be sure the wires are not pinched.
Ŷ6HFXUHWKHMXQFWLRQER[FRYHUZLWKWKHRULJLQDO
screws.
7
INSTALL DUCT COVERS
Ŷ5HPRYHSURWHFWLYHSODVWLF
covering.
Ŷ3ODFHWKHGHFRUDWLYHGXFW
covers on top of the hood.
NOTE: The inside piece has vent
holes on one end intended for
use when the hood is installed for
recirculating purposes. Be sure
the vented end is at the top; the
vent holes will be visible in this
installation.
The inside duct piece must slip into the folded ends
on the outer section.
Ŷ([WHQGWKHLQQHUGXFWXSZDUGWRWKHFHLOLQJEUDFNHW
Ŷ3UHVVXSRQWKHIURQWFRUQHUVRIWKHILOWHUFRYHU
panel to unlock. Lower the panel to access the filter.
Ŷ/RFDWHWKHVFUHZKROHVRQWKHLQVLGHIURQWHGJH
of the opening. Install 2 screws to secure the duct
cover to the hood.
-XQFWLRQ
ER[FRYHU
Mounting
screws
Vent
holes
Lower duct
cover seat
Duct cover
support bracket
Lower duct
cover
Upper duct
cover
Duct
attachment
tabs
Screw holes