Use and Care Guide

10 49-80818
Timer
Gas Lockout
Feature
As a part of the power up sequence, the control
lights up all the display elements. To start the
timer, tap the Timer Start/Off pad once which
prompts the use to start adding time.
Ŷ 7RDGGWLPHWDSWKH+ pad.
Ŷ 7RUHPRYHWLPHWDSWKH– pad.
A single tap on the +- pads results in a 1
minute change in time. Pressing and holding
the +-SDGVZLOODXWRPDWLFDOO\DGGUHPRYH
more time. Time can be added or removed
from a running timer as long as the control
is not locked by tapping the +- pads. After
adding time, wait for 3 sec until the timer starts
count down automatically or to start the timer
immediately, tap the Timer Start/Off pad once.
To cancel a running timer and turn it off, tap the
Timer Start/Off pad once at any time. Once
the timer finishes count down, it expires. It then
starts flashing the display and starts producing
a notification tone of five beeps until the user
either adds more time to the timer or taps the
Timer Start/Off pad to cancel it and turn it off.
This feature can only be used after all the
knobs on the cooktop have been turned off.
If a knob is on, attempting to activate this
feature produces a chime and this feature is
not activated.
To lockout the flow of gas to the cooktop
and to lock the control, press and hold the
Lock Control pad for 3 seconds until a beep
is heard. After the beep the pad must be
released within 5 sec to activated this feature.
Upon activation of this feature, the “LOCKED”
icon on the display will start blinking and
depending on the state will stay lit (locked) or
turn off (unlocked).
It is possible to use the lockout feature while
the timer is running. Once the control is
locked, the timer can’t be turned on again until
the control is unlocked.
The control and the flow of gas can be
unlocked at any time by repeating the
procedure used to lock.
Cooktop Controls
Stainless Steel Gas Cooktops