Installation Guide

49-80512 Rev. 4 
Installation Instructions
INSTALLATION—VENTED TO THE OUTSIDE
DUCTWORK, WIRING LOCATIONS
Ŷ'HWHUPLQHWKHH[DFWORFDWLRQRIWKHYHQWKRRG
Ŷ/RFDWHWKHWHPSODWHSDFNHGZLWKWKHOLWHUDWXUH
Ŷ0HDVXUHIURPWKHIORRUWRWKHWRSRIWKHFRRNLQJ
VXUIDFH$GGKRRGLQVWDOODWLRQKHLJKWGHWHUPLQHGRQ
SDJH0DUNWKDWORFDWLRQ
Ŷ Use a level to draw a straight pencil line on the wall.
Ŷ Tape the template in position along the penciled line.
&+(&.72%(685(7+(7(03/$7(,6/(9(/
Ceiling ducting:
,IGXFWZRUNZLOOYHQWVWUDLJKWXSWRWKHFHLOLQJ
Ŷ8VHDOHYHOWRGUDZDOLQHVWUDLJKWXSIURPWKH
centerline on the template to the ceiling.
Ŷ0HDVXUHIURPWKHEDFNZDOOWRWKHFHQWHUOLQH
of an 8-1/2" hole on the ceiling.
NOTE:,IGU\ZDOOLVQRWSUHVHQWDGGGU\ZDOOWKLFNQHVV
to the 5-1/2" dimension.
Wall Ducting:
,IGXFWZRUNZLOOYHQWWRWKHUHDU
Ŷ8VHDOHYHOWRGUDZDOLQHVWUDLJKWXSIURPWKH
centerline on the template.
Ŷ0HDVXUHDWOHDVWDERYHWKHSHQFLOOLQH
WKDWLQGLFDWHVWKHERWWRPLQVWDOODWLRQKHLJKWWRWKH
centerline of an 8-1/2" dia. duct hole. (Hole may be
elongated for duct elbow.)
HOUSE WIRING LOCATION:
Ŷ7KHMXQFWLRQER[LVORFDWHGRQWKHWRSOHIWVLGHRI
the hood.
Ŷ:LULQJVKRXOGHQWHUWKHEDFNZDOODWOHDVWDERYH
WKHERWWRPRIWKHKRRGDQGZLWKLQRIWKHOHIW
side of the centerline.
1
INSTALL FRAMING FOR HOOD
SUPPORT
IMPORTANT:)UDPLQJPXVWEHFDSDEOHRIVXSSRUWLQJ
OEV
,IGU\ZDOOLVSUHVHQWPDUNWKHVFUHZKROHORFDWLRQVIRU
the top mounting brackets. Remove the template.
Ŷ&XWDZD\HQRXJKGU\ZDOOWRH[SRVHYHUWLFDOVWXGV
at the bracket location indicated on the template.
Ŷ,QVWDOODKRUL]RQWDOVXSSRUWDWOHDVW[EHWZHHQ
two wall studs at the mounting screw location. The
horizontal support must be flush with the room
side of the studs. Use cleats behind both sides of
the support to secure to wall studs.
IMPORTANT: Reinstall drywall for an even mounting
surface.
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
REAR WALL
MOUNTING TEMPLATE
49-80514 10/07 JR
Printed in Mexico
15-7/16″
15-7/16″
10-1/16″
C
L
1-1/4″
1-1/4″
9-7/16″
9-7/16″
TOP
MOUNTING
HOLE
DRILL 1/8″
PILOT HOLE
TOP
MOUNTING
HOLE
DRILL 1/8″
PILOT HOLE
BOTTOM
MOUNTING
HOLE
BOTTOM
MOUNTING
HOLE
NOTE:To p
mounting
screws MUST
engage wood
support.
NOTE: Top
mounting
screws MUST
engage wood
support.
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
Ceiling
+RXVH:LULQJ
Location
C
L
´
´
Min.
:DOOYHQW
´
min. above
installation
height
´FHQWHUOLQHWRZDOO
)25&(,/,1*9(17'8&7,1*
´GLDKROH
Centerline of
installation
space
View from rear
cleats
´PLQRSHQLQJIRUGXFWZRUN
´[´PLQ
mounting support