User Manual

Determine if your cabinet has a
recessed area or a smooth, flat
bottom. See Fig. 1. If smooth, tape
template onto the bottom surface
(Fig. 2). If it is recessed, cut the edges
of the template to fit in the recessed
bottom of the cabinet. it is important
that the edges of the cabinets permit
level installation of the oven.
NOTE: On some cabinets a small
bracket or glue block is used between
the overhang and the underside of the
cabinet bottom. Cut the template to fit
around the bracket or glue block so that
template will lie flat against the bottom
of the cabinet.
Tape the Top Cabinet Template to
the underside of the top cabinet in the
recessed area. Fig. 3.
NOTE: Make sure the rear of the
template touches the back wall (for
smooth, flat bottom cabinets) or the
back of the recess (for recessed bottom
cabinets) after cutting the edges of the
template.
Drill 3/8” diameter holes at A. & B.
CAUTION: Wear safety goggles when
drilling holes in the cabinet bottom.
Cut out the 2” diameter hole at D
for power cord. If cabinets are metal,
use the nylon grommet (see the Parts
Included section in the Installation
Instructions) to surround the opening
to protect the cord.
(FOR VERTICAL EXHAUST ONLY)
Cut out shaded area E through the
cabinet bottom for Vertical (Outside)
Exhaust locaton.
Remove the top cabinet template.
For recessed cabinets, make 2 filler
blocks out of scrap wood the size of the
shaded areas F & G. These filler
blocks must have a thickness equal to
the depth of the cabinet recess. Drill 3/8”
diameter holes in these blocks to line
up with A & B. Place the blocks so that
the holes in each block line up with the
corresponding holes in the cabinet. The
filler blocks should be at the same level
as the bottom edge of the wall cabinet
frame. Fig. 4.
RETURN TO AND PROCEED
WITH THE INSTALLATON
INSTRUCTIONS.
FILLER BLOCK AREA
DRILL
DIAMETER 3/8”
3/8”
13 - 31/32”
13 - 31/32”
FILLER BLOCK AREA
DRILL
DIAMETER 3/8”
3/8”
TOP CABINET TEMPLATE
E.CUT OUT FOR VERTICAL (OUTSIDE)
EXHAUST ONLY
CUT HOLE THROUGH CABINET BOTTOM FOR EXHAUST ADAPTOR
5 - 1 / 8”
6 - 7/16”
12 - 13/16”
4 - 1 / 2”
D. POWER CORD
DRILL
DIAMETER 2”
2”
WALLWALL
10 - 1 / 2”
TOP CABINET TOP CABINET TOP CABINET TOP CABINET TOP CABINET
FILLER BLOCKS
FIG. 4
FIG. 3FIG. 2
FIG. 1
Recessed
Bottom
Cabinet
7.
6.
5.
4.
3.
2.1.
Smooth
Flat Bottom
Cabinet
RIGHT SIDE
LEFT SIDE
31-7000189 Rev. 0 09-22 GEA
NOTE: IT IS VERY IMPORTANT TO READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS BEFORE PROCEEDING WITH THIS
TOP CABINET TEMPLATE.
This template is used to locate the power cord clearance hole, cabinet mounting holes and
the vertical exhaust cutout.