Installation Instructions Built-In Dishwashers ZBD6800 ZBD6880 ZBD6890* ZBD0700* ZBD0710 Design Guide with Installation Instructions *For ZBD6890 and ZBD0700 also refer to the instructions provided on the template packed with that model.
Safety Information BEFORE YOU BEGIN IMPORTANT Readthese instructionscompletely and carefully. IMPORTANT- Save these instructions for local inspector's use. Observe all governing codes and ordinances. • Note to Installer If you received a damaged dishwasher, you should immediately contact your dealer or builder. READ CAREFULLY. KEEP THESE INSTRUCTIONS. -- Besure to leavethese instructions with the Consumer.
Installation Preparation PARTS SUPPLIED: [] Two #8-18 x 5/8"Phillips special head screws, to secure dishwasher to underside of countertop or sides of cabinets. (Tapedto top side of dishwasher.
Installation ADVANCE PLANNING DISHWASHER • These dishwashers are designed for versatility, adaptable to virtually any installation. • All models have a full length door without the traditional access panel. • These dishwashers may be installed beneath countertops of stone or other materials that will not accept screws. No trim kit required.
Installation Preparation DRAIN REQUIREMENTS Method 1--Air Gap with Waste Tee or Disposer An air gap must be used when required by local codes and ordinances. The air gap must be installed according to manufacturers instructions. • Follow local codes and ordinances. • Do not exceed 10 feet distance to drain. • Do not connect drain lines from other devices to the dishwasher drain hose.
Installation Preparation PREPARE ELECTRICAL WIRING FOR PERSONAL SAFETY:Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord or adapter plug with this appliance. WARNING 1-1/2" Dia. Hole(Max.) Electrical Requirements • This appliance must be supplied with 120V,60 Hz., and connected to an individual properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delav fuse.
Installation Instructions BEFORE YOU BEGIN PREPARE HOT WATER LINE • The line may enter from either side, rear or floor within the shaded area shown in Figure E • The line may pass through the same hole as the electrical cable and drain hose. Or, cut an additional 1-1/2" dia. hole to accommodate the water line. If power cord with plug is used, water line must not pass through power cord hole.
Installation Instructions [STEP41INSTALL ISTEP 21REMOVE WOOD BASE, INSTALL LEVELING LEGS POWER CORD UsePower CordKit WX09XT0910 availablefor purchasefroman authorizedGEAppliancesdealer. IM PORTANT- Do notkickoff woodbase!Damage will occur. Skipthisstepif dishwasherwill bedirectwired or hasa factoryinstalledpowercord. • Move the dishwasher closeto the installationlocation and layit on its back.
Installation Instructions ISTEP61POSITION WATER LINE ISTEP 81 SLIDE DISHWASHER PARTIALLY INTO CABINET AND HOUSING WIRING DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. DAMAGE WILL OCCUR. • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher. " " • Slide dishwasher into the opening a few inches at a time. 4" _,,5___ __ ...._:__ House\\ \ W_tner Wiring _ FigureM _er \ Do Not PushAgainst Front Door P
Installation ISTEP 101 POSITION DISHWASHER Instructions UNDER COUNTERTOP • Push the dishwasher into the cabinet. • Push at the sides with your hands. Do not use your knee against the door since door damage will occur. • Check that the tub insulation blanket does not get "bunched-up" or interfere with the springs as you slide it into the cabinet. • Center the dishwasher in the opening.
Installation Instructions ISTEP 111 LEVEL DISHWASHER IMPORTANT- • Level the dishwasher by adjusting the four leveling legs individually. • Make sure 1/2" minimum gap is maintained (see Figure V). Dishwasher must be level for proper dish rack operation and wash performance. and rack track inside • Place level on door the tub as shown to f / check that the //(fi _// dishwasher is level.
Installation ISTEP 121 SECURE DISHWASHER Instructions TO CABINET Method 1--Secure dishwasher to wood countertop • Fasten the dishwasher to the underside of the countertop with 2 Phillips screws provided, The dishwasher must be secured to the countertop or the cabinet sides. When countertops are made of wood, use Method 1. When countertops are granite or other materials that will not accept screws, use Method 2 to secure dishwasher atthe sides.
Installation Instructions ISTEP 131CONNECT WATER SUPPLY Connect water supply line to 90° elbow. • Slide compression nut, then ferrule over end of water line. • Insert water line into 90° elbow. Line • Slide ferrule against elbow and secure with compression nut. IMPORTANT- Check to be sure that door spring does not rub or contact the fill hose or water supply line. Test by opening and closing the door. Re-route the lines if a rubbing noise or interference occurs.
Installation Instructions ISTEP 151CONNECT POWER SUPPLY ISTEP 161PRE-TEST Skip this step if equipped with power cord, Go to step 16. Verify that power is turned off at the source, Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty, • Remove junction box cover "A". [] Check to be sure power is OFF. • Secure house wiring to the back of the junction box with a strain relief "B".
Installation Instructions/Custom ISTEP 171 DISHWASHER Panel Dimensions [STEP191LITERATURE WET TEST [] Turnon power supply (or plug power cord into outlet,if equipped). • Be sure to leavecompleteliterature packageand installation instructionswith the consumer. [] Start the unitto checkfor leaks. - PushRINSEONLYpad. - PushSTART/RESET pad one time. - Closedoor. CUSTOM ZBD6890, [] Checkto be sure that water enters the dishwasher.
NOTE:While performing installations described in this book, safety glasses or goggles should be worn. I_." Motwg'r.m °'_loon! ._t._-vic_" itt yo_tr _tre., .ill l. 800.444. 1845. NOTE: Pro(hl(:t iml)rov¢_m(nl is a cot_tinuing (:ride ax'or _t (;(_n(_l-_d El(_(tric. Tller(_i_r(, malel-ials, _q)l)(_n-an(¢_ Sl)(_(i_](_lions _t'(_ sul)je(t to (ll_lng(' wilhoul noli(¢!. and Monogram: Pub.No. 31-30586 ] PartNo.
