Owner`s manual

Installation Instructions
ISTEP131CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
• Slide compression nut, then ferrule over end of
water line.
• Insert water line into 90° elbow.
• Slide ferrule against elbow and secure with
compression nut.
IMPORTANT- Check to be sure that door
spring does not rub or contact the fill hose or water supply
line. Test by opening and closing the door. Re-route the
lines if a rubbing noise or interference occurs.
DoorSpring
90° Elbow
Line
Figure CC
ISTEP 141CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES,
The drain hose molded end will fit 5/8" or 1"diameter
connections on the air gap, waste tee or disposer. Cut
on the marked line as required for your installation.
FigureDD
Cutting Line
,/
/.
IMPORTANT:Do not cut corrugated
portion of hose
• If a longer drain hose is required, add up to 42" of
length for a total of 10ft. to the factory installed hose.
Use 5/8" or 7/8" inside diameter hose and a coupler to
connect the two hose ends. Secure the connection
with hose clamps.
Figur_
HoseClamp
HoseClamp
Coupler
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEETFORPROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer
using either previously determined method.
Method 1--Air gap with waste tee or disposer
__ re __ re
Waste TeeInstallation Disposer Installation
FigureFF
Method 2--"High drain loop" with waste tee or
disposer
Fasten to underside
_ _ of countertop,
Waste Tee Installation
Fasten to underside
i_ of countertop,
32"
Disposer Installation
Figure GG
IMPORTANT-when i--_/__ Remove
connecting drain line to disposer, _1 Hopper
check to be sure that drain plug has ,._ Plug
been removed. DISHWASHER WILL
NOT DRAIN IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always
be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
13