Owner`s manual

Installation Instructions/Custom Panel Dimensions
ISTEP 171 DISHWASHER WET TEST
[] Turnon power supply(or plugpower cord into outlet,if
equipped).
[] Startthe unitto checkfor leaks.
- PushRINSEONLYpad.
- PushSTART/RESETpadonetime.
- Closedoor.
[] Checkto besure thatwater entersthe dishwasher.If water
does not enter the dishwasher,check to besure thatwater
and power areturned on.
[] Checkfor leaksunderthe dishwasher.If a leak isfound,turn
power supplyoff,then tighten connections.Restorepower
after leak is corrected.
[] Checkfor leaksaroundthe door.A leakaroundthe door
could be causedby door rubbingor hittingagainstadjacent
cabinetry.Repositionthe dishwasherif necessary.SeeStep12.
[] Thedishwasherwill drainandturn off about 5minutesafter it
was started.Checkdrain lines.If leaks arefound,turn power
off atthe breakerand correct plumbingas necessary.Restore
power after correctionsare made.SeeStep 15.
[] Opendishwasherdoorand makesure most of the water has
drained.If not,check that disposerplughas beenremoved
and/or air gap is not plugged.SeeStep14.Also check drain
linefor kinking.
[] Runthe dishwasherthrough another "Rinse0nly" cycle.
Checkfor leaksand correct if required.
ISTEP181REPLACE TOEKICK
• Placetoekickagainstthe legs of the dishwasher.
t
Figure II
• Alignthe toekick with the bottomedgeand makesureit is
againstthe floor.
• Insert andtightenthe two toekick attachmentscrews. The
toekick shouldstayin contactwith the floor.
TIP: Make suretoekick is againstfloor to minimizenoise.
15
[STEP191LITERATURE
• Besure to leavecompleteliterature packageand installation
instructionswith the consumer.
CUSTOM PANEL FOR MODEL
ZBD6890, ZBDO700
Thesedishwashersrequireafield installed3/4"thick custom
paneland customhandle.An installationtemplateis packed
with thesemodelsandmay beobtainedin advance.Order
Pub.No.31-30569-1.Completepanelinstallationinstructions
are includedonthe template.
CUSTOM PANEL SEE REQUIREMENTS
HEIGHT
Panelheightmustbe between30-1/16"and30-1/4".
30-1/16" Min.
30-1/4" Max.
_23-3/4"_
• Ifthe panelheightis morethan30-1/4"it will preventthe door
from swingingopen.
• Ifthe panelheightis lessthan 30-1/16"it will not coverthe
dishwasherdoorframe.
• Thetop of the custompanelmust beflush with the top of the
door.The 1/2"minimumgap betweenthe top of the doorand
the bottomof the countertopmustbemaintained.
WIDTH
Countertop
Z2"mio
Panelwidth mustbe23-3/4".
• Ifthe panelwidth is lessthan 23-3/4"it will not coverthe
dishwasherframe.
IMPORTANT:Toensureoptimumdoorbalanceperformance,
thecustompanelmustnotweigh morethan14Ibs.