Owner`s manual
Installation Instructions
ISTEP21REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT- Do notkickoff woodbase!Damage
will occur.
• Move the dishwasher closeto the installationlocationand layit
on its back.
• Removethe four leveling legs onthe undersideof the
wood basewith anadjustablewrench or 15/16"socket.
• Discard base.
Figure H
• Screw levelinglegs backinto the dishwasherframe,
approximately1/4"from frame as shown.
ISTEP31REMOVE TOEKICK
• Removethe two toekick screws.
FigureJ
Remove2
ToekickScrews
[STEP41INSTALL POWER CORD
UsePowerCordKitWX09XT0910availableforpurchasefroman
authorizedGEAppliancesdealer.
Skipthisstepif dishwasherwill bedirectwired orhasa
factoryinstalledpowercord.
The power cord and connectionsmustcomplywith the National
Electrical Code,Section422and/or local codesandordinances.
• Maximumpower cord length is 4feet beyondthe back of the
dishwasher.
A B
Remove Insert Power
Junction Box CordWires
Cover Strain Relief
_ andTighten
Gr°u L
C CheckThat White, Blackand_
GreenDishwasher Wires Are Threaded
Thru Small Hole in Bracket
Figure K
Whit
D
UseUL Listed _ ///
Wire Nuts _/
• Connectincomingpower cord white (orribbed)to dishwasher
white, black(or smooth)to blackand groundto dishwasher
greenwire. UseULlistedwire nutsof appropriatesize.
• Replacejunction box cover.Besurewires are not pinched
underthe cover.
[STEP 51 INSTALL 90 ° ELBOW
• Wrap 90° elbowwith thread sealtape.
o
• Installa 90 elbow ontothe water valve.
Frontof Dishwasher
8
_ Water Valve
Bracket
90°_
Elbow
II Hose
Thread
FigureL SealTape
• Donot overtighten90° elbow,water valve bracket could bend
or water valvefitting could break.
• Positionthe endof the elbow to face the rear of the dishwasher.