Owner`s manual

Installation Instructions
ISTEP61POSITION WATER LINE
AND HOUSING WIRING
• Position water supply line and house wiring on the
floor of the opening to avoid interference with base
of dishwasher and components under dishwasher.
FigureM
" " 4"
_,,5_____...._:__
House\\ \
W_tner Wiring _ \
ISTEP71INSTALL DRAIN HOSE,
GUIDE THROUGH CABINET
• Remove tape and wire tie holding the clamp to the
drain hose. Be careful not to damage the drain hose.
• Stand the dishwasher upright.
• Slip the supplied
hose clamp over
the large end of
the hose. Do not
tighten.
Figure N
• Push hose over the drain outlet on the back side of
the dishwasher. See illustration. Push the hose over
the outlet and against the shoulder stop,
• Tighten the hose clamp with a 1/4" nut driver.
Insulation
Blanket Water
Figure0
House
Wiring
Power Cord
(If Used)
• Position the dishwasher in front of the opening.
Insert drain hose into the cabinet side. If power cord
is used, guide the end through a separate hole, 9
ISTEP 81SLIDE DISHWASHER
PARTIALLY INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches
at a time.
Do Not PushAgainst
FrontDoor PanelWith
Knee. Damageto The
Door PanelWill Occur.
_er
by Grasping Both
Sides With Hands
FigureP
• As you proceed, pull the drain hose through the
opening under the sink. Stop pushing when the
dishwasher is a few inches forward of adjacent
cabinetry.
• Make sure drain hose is not kinked under the
dishwasher and there is no interference with the
water line and wiring or any other component.
ISTEP 91 INSTALL TRIM PIECES
Skip this step if trim is not supplied with the
dishwasher.
• Locate trim strips inside dishwasher,
• Press trim onto the tub flange on each side, Start
with the top edge, pressing on as you move towards
the bottom,
• Press the two top trim pieces on each side of
the latch,
• Open and close the door to check that trim does not
bind and does not interfere with door latch.
Trim Strip
Strip
Figure Q