Specifications

– 12 –
9. Remove the door switch from the door latch
mounting bracket.
10. Inspect the door latch spring. Make sure the
door latch flap fits properly in the door latch
flap hole. If the spring is misaligned, broken,
or missing, insert a new spring in the spring
post holes.
Bracket
Switch
7. Remove the 4 screws that connect the door
switch mounting bracket to the control panel
cover.
8. Pull the door switch assembly down far
enough so that the door latch cup clears the
door latch mounting bracket.
Assembly
Door Switch and Latch Assembly
The door switch and latch assembly is located on
the door assembly behind the control panel cover.
The dishwasher will not operate until the door is
closed, the latch engages the door catch (holding
the door firmly against the seal), and the normally
open contacts of the double-pole, single-throw
door safety switch are closed.
Removal and Installation
1. Disconnect the electric supply from the
dishwasher.
2. Open the dishwasher door.
Caution: Place a cloth or cardboard between the
control panel and the dishwasher door to prevent
marring the door.
3. Remove the 6 screws that connect the control
panel cover to the dishwasher door. (See
Timer, step 6.)
4. Close the dishwasher door.
5. Release the door latch and allow the control
panel cover to hang against the dishwasher
door.
Note: There are 6 terminals on the door switch.
The top 2 terminals (1) and (2) are not used. The
middle 2 terminals are marked (3) and (4). The
bottom 2 terminals are marked (5) and (6).
6. Tag and disconnect the 4 wire terminals from
the door switch.
Pull
Cup
Flap
Spring