Specifications

– 15 –

5. Inspect the o-ring. If the o-ring shows obvious

signs of wear or damage, replace the duct vent

and gasket assembly.

Static Dry System

The static dry system operates through a vent

located behind the left side of the door panel. The

vent allows hot air to exit the dishwasher tub and

gradually remove moisture.

Removal

1. Open the dishwasher door.

2. Remove the door panel. (See

Door Panel.)

3. Remove the control panel (see

Control Panel)

and allow the control panel to hang against the

dishwasher door.

4. Unscrew the static vent channel cover and

remove the assembly as shown below. Inspect

the cover for hard water/lime deposits or debris

and clean if necessary.

Channel

Cover

This action moves the cover catch (2) and releases

the detergent cover.

When deactivated (3), the lever resets to rest under

the notch in the center of the connecting rod.

Detergent/Rinse Module

The detergent/rinse module sends a signal to turn on

the "LOW RINSE AID" LED on the control panel when

the rinse agent is low.

The detergent/rinse module automatically dispenses

both the detergent and the rinse agent at the

appropriate times. The module is activated twice

during a wash cycle.

The ﬁ rst time the module is activated (1), the lever

slides up the right-hand path of the connecting rod.

Cover

(Continued next page)

O-Ring

Duct Vent