Specifications

– 17 –
Door Assembly
Removal and Replacement
1. Disconnect power.
2. Carefully pull the dishwasher out from its
installation.
3. Remove the control panel. (See Control Panel.)
4. Remove the door foam wire guide and place the
control panel on a cloth or cardboard protected
surface.
5. Remove the detergent/rinse module. (See
Detergent/Rinse Module.)
6. Remove the static dry system. (See
Static Dry
System.)
7. Remove the bolt and ground wire from the door.
8. Remove the wire harness from the door.
(Continued next page)
Note: There is a door hinge assembly on both the
left and right sides of the dishwasher. Both door
hinge assemblies must be removed in order to
remove the door. The procedure to remove the
right-side door hinge assembly is outlined in steps
9 through 19. The left-side door hinge assembly is
identical.
9. Remove the 4 screws, access panel, and toe-
kick panel from the dishwasher.
Bolt and
Ground Wire
Wire Harness
Key
Bracket
10. Mark the position of the spring bolt key in the
mounting bracket with a felt-tip marker.
11. Pull the spring and spring bolt key from the
mounting bracket.
12. Lift the bottom of the spring loop from the hinge
arm stud.
Loop
Stud