Specifications

– 24 –

5. Label and disconnect the two wires from the

drain pump.

Port

Drain Pump Assembly

The drain pump assembly is located under the tub

at the right, rear corner. The drain pump operates

on 120 VAC and is energized 60 seconds after the

wash pump shuts down, to remove any water in the

dishwasher sump. The drain pump forces the water

out the drain line. A check valve ﬂ apper on the drain

pump prevents the dirty water from reentering the

sump.

Removal and Replacement

1. Disconnect power.

2. Carefully pull the dishwasher out from its

installation.

3. Remove the 4 Phillips-head screws, access panel,

and toe-kick panel from the dishwasher.

4. Remove the drain tube (not shown) from the

drain tube port.

Drain Pump

9. Remove and save the 2 screws, lock washers,

and mounting bracket from the drain pump.

Caution: The clamp is easily damaged during

removal and should not be reused. Replace the old

clamp with a new universal clamp (part number:

WH1X2036).

7. Remove the clamp from the sump interconnect

hose.

8. Remove the drain pump from the sump

interconnect hose.

6. Remove the 2 Phillips-head screws that attach

the pump mounting bracket to the frame.

Interconnect

Hose

Clamp

Mounting Bracket

2 Screws

2 Lock-washers