Specifications

– 25 –
4. Label and disconnect the 2 terminals to the
motor wire connector.
Connector
Motor Pump Assembly
The motor pump assembly is located under the tub
behind the sump assembly. This dishwasher model
uses a capacitor start induction motor. The motor
rotates clockwise (as viewed from the terminal end)
and draws approximately 1 amp (±10%) at 120 VAC
(±10%).
Removal and Replacement
1. Disconnect power.
2. Carefully pull the dishwasher out far enough
from its installation to access the drain pump
from the rear of the dishwasher.
3. Label and disconnect the 2 wires to the
capacitor.
Capacitor
(Continued next page)
Caution: The clamp is easily damaged during
removal and should not be reused. Replace the old
clamp with a new universal clamp (part number:
WH1X2036).
6. Remove the clamp from the main conduit
interconnect hose.
Caution: The clamp is easily damaged during
removal and should not be reused. Replace the old
clamp with a new universal clamp (part number:
WH1X2036).
5. Remove the clamp from the motor sump
interconnect hose.
Clamp
Clamp
Interconnect
Hose
Interconnect
Hose